Bedienungsanleitung Black Decker BDV040 T1 (Seite 6 von 76) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

581361

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

ENGLISH

Note: When connecting to a vehicle's 12 Vdc accessory

outlet, it may be necessary to turn on the vehicles ignition to

power the accessory outlet, the unit will beep continuously if

the 12Vdc accessory outlet is not accepting charge.

X When the green vehicle boost LED (4) lights

continuously and the unit beeps, (after approximately

20 minutes), the vehicle battery has been boosted.

X Remove the 12 Vdc vehicle charging adaptor (10) from

the the vehicle's 12 Vdc accessory outlet.

Warning! You must remove the 12 Vdc vehicle adaptor from

the 12 Vdc accessory outlet on the vehicle before attempting

to drive the vehicle. Failure to do so could result in some

cases of the engine continuing to run even when the ignition

key is removed which could result in personal injury or

property damage.

X Turn the vehicle ignition and crank the engine in 5-6

second bursts until engine starts.

Note: Do not attempt to start the vehicle until the boosting

cycle has been completed.

Note: The battery booster will not function while the unit is

recharging or while the 12 Vdc accessory outlet (2) is in use.

X After use, turn the unit off by pressing the on/off button

(3) and recharge the unit as soon as possible so that it

is ready for the next emergency.

Warning! The end of the vehicle charging adaptor will be hot

to touch during and after boosting the vehicles battery.

Using the 12 Vdc portable power supply (fig. A)

This portable power supply can be used with all 12 Vdc

accessories equipped with a male accessory outlet plug

rated up to 5 amps.

Warning! Do not attempt to use the battery booster or

recharge the unit while the 12 Vdc accessory outlet (2) is in

use.

X Lift the cover of the 12 Vdc accessory outlet (2).

X Insert the 12 Vdc plug from the appliance into the 12

Vdc accessory outlet (2) on the top of the unit.

Warning! Do not exceed a 5A load.

X Turn the unit on by pressing the on/off button (3). The

unit will beep once and the red power LED (11) and the

battery status LED (13) will light.

Using the LED area light (fig. A)

Note: The LED area light will only operate if the unit is

switched on.

X Turn the unit on by pressing the on/off button (3).

X Press the area light on/off button (6) on the top panel of

the unit to turn the LED area light (8) on.

X Press the area light on/off button (6) on the top panel of

the unit to turn the LED area light (8) off.

Make sure that the LED area light is turned off while the unit

is being charged or stored.

Maintenance

Your Black & Decker tool has been designed to operate over

a long period of time with a minimum of maintenance.

Continuous satisfactory operation depends upon proper tool

care and regular cleaning.

Warning! Before performing any maintenance or cleaning

on the appliance, unplug the appliance.

X From time to time wipe the appliance with a damp cloth.

Do not use any abrasive or solvent-based cleaner. Do

not immerse the appliance in water.

Replacing the fuse in the vehicle dc vehicle adapter

X Remove the gold cap by turning it counter clockwise.

X Remove the rubber washer, centre pin and the spring.

X Remove the fuse.

X Fit a new fuse of the same type and size (8 A).

X Install the centre pin, spring and rubber washer.

X Install the gold cap by turning clockwise onto the plug.

Protecting the environment

Should you find one day that your appliance needs

replacement, or if it is of no further use to you, think

of the protection of the environment. Black &

Decker repair agents will accept old Black &

Decker tools and ensure that they are disposed of

in an environmentally safe way.

Separate collection of used products and

packaging allows materials to be recycled and

used again. Re-use of recycled materials helps

prevent environmental pollution and reduces the

demand for raw materials.

Local regulations may provide for separate collection of

electrical products from the household, at municipal waste

sites or by the retailer when you purchase a new product.

Black & Decker provides a facility for the collection and

recycling of Black & Decker products once they have

reached the end of their working life. To take advantage of

this service please return your product to any authorised

repair agent who will collect them on our behalf.

You can check the location of your nearest authorised repair

agent by contacting your local Black & Decker office at the

address indicated in this manual. Alternatively, a list of

authorised Black & Decker repair agents and full details of

our after-sales service and contacts are available on the

Internet at: www.2helpU.com.

Black & Decker batteries can be recharged many

times. At the end of their useful life, discard

batteries with due care for our environment:

X Do not dispose of the battery in fire, as this may result in

an explosion.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker BDV040 T1 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Black Decker BDV040 T1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info