Bedienungsanleitung Black Decker BDV1084 (Seite 7 von 100) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

53627

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

ENGLISH

X The digital display (2) shows FLO when topping off the

battery and returns to FUL when completed.

X To view the battery voltage, press the battery voltage

pushbutton (10).

Warning! If the battery size is not known, charge at the 2 A

rate. DO NOT overcharge batteries.

Alternator check (fig. A)

Warning! Check only 12 Vdc systems.

Part 1 (no load)

X Make sure that there is no load on the alternator by turning

off all the vehicle's accessories.

X The battery must be fully charged before testing the

alternator.

X Run the engine long enough to achieve normal idle speed

and verify that there is a no-load voltage.

X Press the alternator check pushbutton (9) to start the check.

X The alternator good LED (8) will light to indicate that the

alternator is good, or the fault LED (5) will display to

indicate that the alternator is out of typical voltage range.

X Press the alternator check pushbutton (9) again to stop the

test.

Part 2 (under load)

X Load the alternator by turning on as many accessories as

possible, except for air-conditioning and defrost.

X Press the alternator check pushbutton (9) to start the test.

X The alternator good LED (8) will light to indicate that the

alternator is good, or the fault LED (5) will light to indicate

that the alternator is out of typical voltage range.

X Press the alternator check pushbutton (9) again to stop the

test.

If the first alternator check indicates a good alternator and

the second indicates the alternator is not good, the problem

could be caused by any of the following:

X Loose fan belts.

X An intermittent diode failure.

X Bad connections between the battery and alternator and/or

ground.

Note: The battery voltage pushbutton (10) is disabled in the

alternator check mode.

Note: The fault LED (5) may display because a number of

extra accessory loads have been added to the charging

system, thereby increasing current demand from the

alternator. Make sure that the alternator is rated to support

the application.

Note: This check may not be accurate for every make,

manufacturer and model of vehicle.

Approximate charging times

The battery charger will automatically adjust the charge rate

as the battery becomes charged and stop charging when the

battery is fully charged. Deep cycle batteries may require

longer charging times.

For estimates of the time it takes to charge a battery, refer

to the following table:

*NR = Not recommended at 2 A - use a higher charge rate.

The times shown in the table above are approximate and

refer to a 50 Ah automotive battery.

Example

A 50 Ah, 12 Vdc battery is discharged (50%). To determine

the time it takes to charge at the 10 A rate, see the chart

above under "50%" and "at 10 A rate".

The battery charging times will vary depending on the size,

age and condition of the battery. Smaller batteries should be

charged at a lower rate (2 A) and an extra hour added to the

charge time.

Maintenance

Your Black & Decker tool has been designed to operate over

a long period of time with a minimum of maintenance.

Continuous satisfactory operation depends upon proper tool

care and regular cleaning.

Warning! Before performing any maintenance or cleaning on

the appliance, unplug the appliance.

X From time to time wipe the appliance with a damp cloth. Do

not use any abrasive or solvent-based cleaner. Do not

immerse the appliance in water.

X After each use, clean the battery clamps (4) and be sure to

remove any battery fluid that will cause corrosion of the

clamps (4).

X Clean the outside case of the battery charger with a soft

cloth and, if necessary, mild soap solution.

X Do not allow liquid to enter the battery charger. Do not

operate when the battery charger is wet.

X Keep the battery charger cords loosely coiled during

storage to prevent damage to the cords.

% of charge in the battery

Rate 75% 50% 25% 0%

2A 7 hrs 14 hrs NR* NR*

6A 2.5 hrs 4.7 hrs 7 hrs 9.2 hrs

10A 1.4 hrs 2.8 hrs 4.2 hrs 5.5 hrs

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker BDV1084 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Black Decker BDV1084

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info