Bedienungsanleitung Black Decker FSMH1321JSM (Seite 10 von 80) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

709563

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

ENGLISH

(Original instructions)

Using Autoselect

, choose from one of the following

applications by turning the Autoselect

dial (2) until the

required setting is selected.

Setting Mop Hand held

Wood/Laminate High temperature steam for

windows



Stone/Marble

 

Tiles/Vinyl Low temperature steam for

heavy grime

  

The steam mop will select the correct volume of steam

required for your particular cleaning operation.

Note: Always check you are using the correct setting before

using your steam mop.

Steam Burst (Fig. C1) (only available with units

FSMH1310SM, FSMH13151SM)

The oor head (12a) is equipped with a steam burst pedal to

aid in the removal of stubborn marks and stains.

u During use, press the steam burst pedal to apply extra

cleaning power.

u To revert back to normal setting press the pedal again.

Hints for optimum use

General

Caution: Never use the steam mop without rst attaching a

cleaning pad.

u Always vacuum or sweep the oor before using the steam

mop.

u The easiest way to use the appliance is to tilt the handle

to a 45º angle and clean slowly, covering a small area at a

time.

u Use water only with no additives or chemicals with your

steam mop. To remove stubborn stains from vinyl or

linoleum oors, you can pre-treat with a mild detergent

and some water before using the steam mop.

Steam Cleaning with the mop

u Fit hand held steam cleaner (5) to the steam mop body

(11)

u Place a cleaning pad (13) on the oor with the velcro 'loop'

side facing up.

u Lightly press the steam mop down onto the cleaning pad

(13).

u Connect the steam mop to the mains.

u Press the ON/OFF button (1). It takes approximately 15

seconds for the steam mop to heat up.

u Turn the Autoselect

dial (2) until the required setting is

reached. After a few seconds steam will start to come out

of the steam head.

Note! When rst lled or after running dry, it can take up to 45

seconds for steam to be produced.

u It takes a few seconds for steam to enter the cleaning pad.

The steam mop will now glide easily over the surface to be

sanitized/cleaned.

u Push and pull the steam mop slowly across the surface to

thoroughly steam clean each section.

u When you have nished using the steam mop, return

the handle (8) to the upright position, making sure that it

is supported and turn it 'OFF'. Wait until the steam mop

cools down (approximately ve minutes).

Caution! It is important to monitor the water level in the

water tank. To rell the water tank and continue to sanitize/

clean stand the mop upright making sure that the handle is

supported and turn the steam mop 'OFF'. Unplug the unit from

the electrical wall outlet, and rell the water tank.

Caution! Never leave the steam mop in one spot on any

surface for any period of time. Always place the steam mop

with the handle (8) supported in the upright position when

stationary and make sure the steam mop is turned off when

not in use.

Carpet refreshing

u Place a cleaning pad (13) on the oor with the 'loop' side

facing up.

u lightly press the steam mop down onto the cleaning pad.

u Place the carpet glider (12b) on the oor.

u Lightly press the steam mop down onto the carpet glider

until it clicks into place.

u Connect the steam mop to the mains.

u Press the ON/OFF button (1). It takes approximately 15

seconds for the steam mop to heat up.

u Turn the Autoselect

dial (2) to the Wood/Laminate

setting.

u Push and pull the steam mop slowly across the carpet to

thoroughly refresh each section.

u When you have nished using the steam mop, return the

handle (8) to the upright position and turn the unit OFF.

Wait until the steam mop cools down (approximately ve

minutes).

After use

u Turn the Autoselect

dial (2) to the OFF position.

u Wait until the steam mop cools down.

u Unplug the steam mop from the electrical wall outlet.

u Empty the water tank.

u remove the cleaning pad (13) and wash it ready for next

use (take care to follow the wash care instructions printed

on the cleaning pad).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker FSMH1321JSM Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info