Bedienungsanleitung Black Decker GRC950 (Seite 6 von 38) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

474480

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

Lead acid batteries can be harmful to the

environment and can explode when

exposed to fire. Do not incinerate.

The battery should be taken to a

Black & Decker authorised service agent,

your local dealer or your local recycling

station. If necessary, contact your local

authority for disposal information.

If the cutting performance begins to

deteriorate, please refer to the “Fault

finding” guide.

Warning! Do not cross battery leads when

installing a new battery as this will cause the

blade to run in reverse until battery is

discharged. When you attempt to recharge

the battery, the charger circuit will be

destroyed as soon as you connect the

charger plug.

How to use your mower (Fig. F & G)

Observe all of the relevant warnings when

using your mower.

Warning! Never attempt to operate your

machine with one hand. You must guide

your machine with both hands.

Safety key

• In order to prevent accidental start-up or

unauthorised use of your cordless

mower, a removable safety key has been

incorporated into the design of your

mower. The mower will be completely

disabled when this safety key has been

removed from the mower.

Warning! Always remove the safety key from

mower when leaving it unattended, even for

a short period of time.

• Your safety key will be found in the

parts pack (plus one spare).

Starting

• Lift the fuse cover (21).

• Insert the safety key (23) into position

and push fully home.

• Close the fuse cover (21).

• Tilt the handle downwards to slightly

raise the front of the mower to reduce

the risk of lawn damage whilst starting.

• Your mower is equipped with a special

on/off switch lever. To operate your

mower, press the button on the switch

box then pull the lever towards you. Hold

in this position to keep the mower running.

• To turn the mower off, just release the

lever. The spring-loaded “snap-action”

lever will relocate itself back into its

original position inside the switch housing.

When you have finished using your machine

we recommend that you clean all debris from

it before putting it away. It is important to

remove the safety key before cleaning. Please

refer to the “Care and maintenance” section.

Note: To obtain the best results cut your

lawn or grassed area regularly and do not

cut when the grass is wet.

If, when grasscutting, loose grass is seen to be

scattered from beneath the mower, the grass-

bag is probably full and should be emptied.

Blade maintenance

The steel blade is designed to give a fine

finish in long or tough grass. The blade will

continue to cut even when it has become

blunt or burred. There is no need for it to be

razor sharp.

If, however, because of damage or wear the

cutting performance deteriorates, then your

mower may require a new blade, or at least

the existing blade to be sharpened.

We recommend that the steel blade is

sharpened or a new blade fitted at the

beginning of each season.

Replacement blades are available from

Black & Decker service agents.

Warning! When fitting a new blade use only

the Black & Decker replacement part

specified for your mower - do not attempt to

fit any other blade.

Fitting a new blade (Fig. H)

Observe all the relevant warnings before

changing the blade.

Warning! Remove safety key before

changing the blade.

• Turn your machine over on its side so

that the underside of the cutter deck is

exposed.

• Wear gloves to protect hands.

• Using a cloth placed over the blade or

heavy duty gloves to protect your hands,

grip the blade and, using the spanner

provided, loosen and remove the nut from

the motor spindle. Turn the nut in an anti-

clockwise direction to loosen it.

• Remove nut (18), square washer (17),

clutch plate (16) and blade.

• To replace blade ensure the cutting

edges of the blade are closest to the

ground and place blade onto the

combined mount.

• Place the clutch plate over the shoulder

of the combined mount protruding

GRC450/750 ML p01-38 16/3/00, 3:13 pm6

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GRC950 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info