Bedienungsanleitung Black Decker GRC950 (Seite 7 von 38) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

474480

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

through the blade. Ensure to align the

inside edges with the outside edges of

the blade.

• Place the square steel blade spacer on

the motor shaft aligning the inside flats

with the shaft and engaging the outside

edges with the plastic clutch plate.

Engage nut on shaft and turn it

clockwise to tighten.

• Ensure that removed parts are replaced

correctly before use, incorrect assembly

may result in damage to your mower

and reduced cutting performance.

Note: This unit is fitted with a clutch plate

(16), between the blade nut and the blade,

which must be assembled correctly at all

times. Damaged blade assembly parts

must be replaced before use.

Care and maintenance

The advice given in this section covers the general

care and maintenance of the main body of your

mower. Advice relating to the blades is given in

“Maintenance of blades”. Advice relating to the

maintenance and storage of the battery is given in

“Battery information”.

• Always keep your mower clean and free from

grass cuttings, especially the underside of the

cutter deck and the air vents.

• At the end of each cutting session we

recommend that the build up of grass on the

underside of the cutter cover is removed using

a blunt scraper. The spanner included with this

mower may also be used for this purpose.

• Clean all plastic components with a damp

cloth.

Caution: Do not use solvents or cleaning fluids as

these may damage the plastic components of your

mower.

Overload protection (Fig. J)

• Your machine is fitted with overload

protection. If you work too quickly in

long grass, or in heavy conditions, you

may overload the motor. If this occurs,

the safety key fuse will blow, causing

the machine to stop.

• This is not a fault of the machine but a

safety device to protect your machine.

• When this occurs, remove the safety

key and inspect the fuse link. If link is

broken, the fuse has blown and needs

to be replaced with a new key. One of

which is supplied as a spare in your

parts pack. Alternatively, you can

purchase a new key from any Black &

ENGLISH

Decker service centre.

To obtain the best results:

• Cut the grass regularly.

• Do not cut wet grass.

• When the grass is longer than 10cm

(4 inches), it is advisable to go over the

lawn on a high cut setting and then

finish using a lower setting.

Fault finding

If your mower does not operate correctly,

use the table below to locate the problem.

Problem Solution

Mower does not run (a) Check to make sure the safety

when switch lever key has been inserted correctly.

is activated (b) Remove the safety key, turn

your mower over and check that

the blade is free to turn.

Re-charge battery.

Mower stops when (a) Remove safety key. Turn your

mowing mower over and check that blade

is free to turn.

(b) Raise cutting height of wheels

and start mower.

charged. Re-charge battery.

(d) Inspect safety key fuse link. If

broken, the safety key has blown

and requires replacement.

Mower runs but (a) Has battery been fully

cutting performance charged? Re-charge battery

is unsatisfactory (b) Battery may need replacing.

Refer to ‘Battery disposal’ section.

Mower is too hard (a) Raise cutting height to

to push reduce drag on grass. Check

each wheel for ease of rotation.

Mower is abnormally (a) Remove safety key. Turn unit

noisy and vibrates on its side and check blade for

damage. If damaged, replace with

Black & Decker replacement blade.

(b) If there is no visible damage

to the blade or underside of the

mower return to your local

service agent.

Warning! Always remove safety key before

carrying out any inspection.

GRC450/750 ML p01-38 16/3/00, 3:13 pm7

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GRC950 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info