Bedienungsanleitung Black Decker KC9651 (Seite 29 von 72) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

472997

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

ENGLISH

The torque adjustment collar has 5 positions and

provides adjustment of the torque necessary to seat

screws of a given size in a particular material.

Proceed as follows:

Set the torque

adjustment collar to

position ‘1’.

Fit and tighten the first

screw. If the clutch of

your drill starts to slip

before the screw is

correctly seated, rotate

the torque adjustment collar, as necessary, until the

clutch slips when the head of the screw is flush with

the surface of the material. Use this torque setting

when fitting the remaining screws.

FAST CHARGER AND DETACHABLE BATTERY PACK

Your drill has a fast charger and detachable battery

pack. To increase the availability of your drill you can

purchase an additional battery pack.

CHARGING YOUR CORDLESS DRILL

Important! The battery pack in your drill is not charged

when supplied as new. A new battery, or one which

has not been used for an extended period, achieves full

performance only after approximately 5 charging and

discharging cycles. Before attempting to charge your

drill, read all the safety instructions.

To charge your drill, proceed as follows:

Put the forward/reverse switch in the centre (lock-off)

position. Remove all accessories from the chuck.

To remove the battery

pack, depress the two

release buttons and

withdraw the battery

pack. Plug the charger

into a standard 220/240V

socket. Place the battery

pack in the charger.

While charging, your

battery pack may hum

and become warm to the

touch; this is normal.

3-5 hour charger

After normal usage your power pack should be fully

charged in 3 hours. If your power pack is run-down

completely it may take up to 8 hours to become fully

charged.

Your power pack was sent from the factory in an

uncharged condition; before attempting to use it, it

must be charged for at least 6 hours.

To prolong your power packs’ life, avoid leaving it on

charge for more than 8 hours. Although overcharging is

not a safety concern, it can reduce the overall life of

your power pack.

1 hour fast charger

Place the battery pack in the charger. Leave it until

the red light goes out and the green light shows. The

battery pack is then ready to use.

If the battery has been used recently and is too hot, the

red charge light still comes on but the charger will not

charge until the battery temperature reduces to below

45˚C. Once below 45˚C you must re-insert the pack to

actually start charging.

The battery charger recognises the charged condition

and switches a fully charged battery immediately to

trickle charging. By this means, the battery can remain

indefinately in the charger without risk to the battery life.

Both chargers

Disconnect the plug from the electricity supply before

making or breaking connections to the battery pack.

For the longest battery life, charge the battery pack in

an air temperature of approximately 24°C/75°F. Do not

charge the battery pack if the air temperature is below

5°C/41°F or above 35°C/95°F.

The charger can remain in the electrical socket

indefinitely without adverse effect. If the battery pack

does not charge correctly, check the supply at the

electrical socket with a lamp or other appliance.

If the electricity supply is satisfactory and your drill is

still not charging, take or send your drill and charger to

your local Black & Decker authorised repair agent.

FITTING THE DRILL OR SCREWDRIVER BIT

Make sure the forward/reverse switch is in the centre

(lock-off) position.

While holding the rear

section of the chuck,

rotate the front section

until the jaws of the

chuck are sufficiently

open. Insert the drill bit

in the jaws of the chuck.

Hold the rear section of the chuck while tightening the

front section. Tighten the two sections firmly in

opposite directions to securely grip the drill bit.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker KC9651 Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info