Bedienungsanleitung Black Decker LM2000 (Seite 11 von 116) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

709484

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

ENGLISH

(Original instructions)

Adjusting mower height (fIg. K)

The height of cut is adjusted by the central cut height adjust

lever, there are 7 positions to choose from.

Note: If you are not sure which height to cut, begin mowing

with the height adjustment lever (7) in position 7 and adjust

the height down as needed, as shown in gure K.

To set the height of cut:

u Pull the mower height adjustment lever out of the locking

notch.

u Move the lever towards the rear of the appliance to lower

the height of cut.

u Move the lever towards the front of the appliance to raise

the height of cut.

u Push the height adjustment lever into one of the 7 locking

notches.

Starting mower

Warning! Sharp moving blade. Never attempt to override the

operation of this switch box as serious injury

could result.

u Your mower is equipped with a special on-off switch box.

To operate the mower, push the button (26) on the switch

box (1), then pull the bail handle (2) to the handlebar as

shown in Figure L. Release button and hold bail handle

with both hands.

u To turn the mower off, just release the bail handle.

Warning! Never attempt to lock a switch or bail handle (2) in

the on position.

Note: Once the bail handle has returned to the original posi-

tion it will activate the “Automatic Braking Mechanism”. The

motor is electrically braked and the mower blade will stop

rotating in 3 seconds or less.

Mowing (g. M - N)

Warning! Always inspect area where mower is to be

used and remove all stones, sticks, wire, bones and other

debris which might be thrown by the rotating blade.

We recommend to use your mower as outlined in this section

in order to achieve optimum results and to reduce the risk of

cutting the main cable.

u Place the bulk of the cable on the lawn, close to the start-

ing point (position 1 in g. M).

u Switch the mower on as described above.

u Proceed as shown in g. M.

u Move from position 1 to position 2.

u Turn right, stepping over the cable and proceed towards

position 3.

u Turn left, stepping over the cable and move towards posi-

tion 4.

u Repeat the above procedure as required.

Warning! Do not work towards the cable as shown in g. M1.

EdgeMax™

EdgeMax™ (11) allows you to cut grass right up to the edge of

a wall or fence (g. N).

EdgeMax™ allows you to accurately cut grass right up to the

edge of your lawn (g. N1).

u With the lawn mower parallel to the edge of your lawn,

push the lawn mower along the edge of the lawn. ensure

that the EdgeMax™ is slightly over the edge of your lawn

(g. N1).

Note: When the side discharge attachment is attached

EdgeMax™ can only be used on the right side of the mower.

Mower overload

To prevent damage due to overload conditions, do not try to

remove too much grass at one time.

Slow down your cutting pace, or raise the cut height.

Storage

Warning! Rotating blade can cause serious injury. Release

bail handle (2) to turn mower off, remove safety key, and re-

move battery before lifting, transporting, or storing the mower.

Store in a dry place.

Warning! To avoid being pinched, keep ngers away from

area between handles when folding down handles.

Warning! Make sure cord does not become stretched or

pinched in the joints of the handles during folding. This can

cause damage to the cord.

The handle of the mower can be easily folded down for quick

and convenient storage.

u Holding onto the handle, open, but do not remove, the

lower-handle attachment levers (6) and fold the handle to

the front of the mower as shown in gure O.

u Open, but do not remove, the upper-handle attachment

levers (5) and fold the upper handle (3) back over the

lower handle (4) as shown in gure P.

u The mower shold be compacted down as shown in

gure Q.

u Keep all nuts, bolts, and screws tight to be sure the appli-

ance is in safe working condition.

u Check the grass catcher frequently for wear or deteriora-

tion.

u Replace worn or damaged parts for safety.

u For rotary mowers, ensure that only replacement cutting

means of the right type are used.

Carrying the mower

u The mower can be carried using the convenient carry

handles (10) as shown in gure R. DO NOT attempt to

lift the mower by grasping the upper handle (3) or lower

handle (4).

Mowing tips

Warning! Always inspect area where mower is to be used

and remove all stones, sticks, wire, bones, and other debris

which might be thrown by the rotating blade.

Warning! Mow across the face of slopes, never up-and-down.

Exercise extreme caution when changing direction on slopes.

Do not mow excessively steep slopes. Always maintain good

footing.

u Release bail handle to turn mower “Off” when crossing

any gravel area (stones can be thrown by the blade).

u Set mower at highest cutting height when mowing in rough

ground or in tall weeds. Removing too much grass at one

time can cause the motor to be overloaded and to stop.

Refer to troubleshooting guide.

u If a grass collection bag (8) is used during the fast growing

season, the grass may tend to clog up at the discharge

opening. Release bail handle to turn mower off and

remove the safety key. Remove the catcher and shake the

grass down to the back end of the bag.

Black Decker LM2000 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info