Bedienungsanleitung Black Decker LM2000 (Seite 13 von 116) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

709484

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

ENGLISH

(Original instructions)

Troubleshooting

If your appliance seems not to operate properly, follow the

instructions below. If this does not solve the problem, please

contact your local BLACK+DECKER repair agent.

Warning! Before proceeding, release the bail bar to turn

mower off and wait for the blade to stop .

Problem Possible solution

Mower doesn’t run when

bail handle is activated.

Check to make sure mower is properly plugged

in and that the button on switch box is being

completely depressed before pulling the bail

handle.

Release bail handle to turn mower off. Remove

safety key and battery pack, turn mower over

and check that blade is free to turn.

Motor stops while mowing. Release bail handle to turn mower off. Unplug

mower. Turn mower over and check that blade

is free to turn.

Raise cutting height of wheels to highest posi-

tion and start mower.

Avoid overloading the mower. Slow down the

cutting pace, or raise the cut height.

Mower runs but cutting

performance is unsatisfac-

tory,

Release bail handle to turn mower off. Unplug

mower. Turn mower over and check:

u Blade for sharpness - Keep blade sharp.

u Deck and discharge chute for clogging.

Wheel height adjustment may be set too low for

grass condition. Raise cutting height.

Mower is too hard to push. Release bail handle to turn mower off. Unplug

mower. Raise cutting height to reduce deck

drag on grass. Check each wheel for free

rotation

Mower is abnormally noisy

and vibrates.

Release bail handle to turn mower off.

Unplug mower. Turn mower on side and

check blade to ensure it has not been bent or

damaged. If blade is damaged, replace with

a BLACK+DECKER replacement blade. If

the underside of the deck is damaged, return

mower to a BLACK+DECKER Authorized

service center.

If there is no visible damage to the blade and

the mower still vibrates:

u Release bail handle to turn mower off.

u Unplug mower.

u Disassemble entire blade assembly as

described in the “Removing and installing

blade” section.

u Remove any debris and clean each piece.

u Replace each piece as described in the

“Removing and installing blade” section.

If mower still vibrates, return the mower to

an authorized BLACK+DECKER authorized

service center.

Mower not picking up

clippings with bag.

Chute clogged. Release bail handle to turn

mower off. Unplug mower. Clear chute of grass

clippings.

Raise cutting height of wheels to shorten length

of the cut.

Bag full. Empty bag more often.

Protecting the environment

Separate collection. Products and batteries

marked with this symbol must not be disposed of

with normal household waste.

Products and batteries contain materials that can be recov-

ered or recycled, reducing demand for raw materials. Please

recycle electrical products and batteries according to local

provisions. Further information is available at

www.2helpU.com

Technical data

LM2000

Voltage

Vac 230V

Power input

W 2000

No-Load Speed

min

-1

3500RPM

Impedence

MAX

0.4103

Weight

25.46

Hand/arm weighted vibration value:

= <2,5 m/s

, uncertainty (K) = 1,5 m/s

(sound preasure) 85 dB(A)

uncertainty (K) = 2,5 dB(A)

EC declaration of conformity

MACHINERY DIRECTIVE

OUTDOOR NOISE DIRECTIVE

LM2000 lawn mower

Black & Decker declares that these products described under

"technical data" are in compliance with:

2006/42/EC, EN 60335-1:2012 + A11:2014,

EN 60335-2-77:2010

2000/14/EC, Lawn Mower, L < 50cm, Annex VI,

DEKRA Certication B.V., Utrechtseweg 310, ED Arnhem

Netherlands

Notied Body ID No.: 0344

Level of accoustic power according to 2000/14/EC (Article 12,

Annex III, L < 50cm, cm):

(measured sound power) 95 dB(A)

uncertainty (K) = 1,0 dB(A)

(guaranteed sound power) 96 dB(A)

These products also comply with directive 2014/30/EU and

2011/65/EU. For more information, please contact Black &

Decker at the following address or refer to the back of the

manual.

The undersigned is responsible for compilation of the technical

le and makes this declaration on behalf of Black & Decker.

R. Laverick

Director of Engineering

Black & Decker Europe, 210 Bath Road, Slough,

Berkshire, SL1 3YD

United Kingdom

26/08/2016

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker LM2000 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info