Bedienungsanleitung Black Decker STC5433B (Seite 11 von 124) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

709494

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

ENGLISH

(Original instructions)

u The battery pack should be recharged when it fails to

produce sufcient power on jobs which were easily done

previously. DO NOT CONTINUE to use under these

conditions. Follow the charging procedure. You may also

charge a partially used pack whenever you desire with no

adverse affect on the battery pack.

u Foreign materials of a conductive nature such as, but

not limited to, steel wool, aluminium foil, or any buildup

of metallic particles should be kept away from charger

cavities. Always unplug the charger from the power supply

when there is no battery pack in the cavity. Unplug charger

before attempting to clean.

u Do not freeze or immerse charger in water or any other

liquid.

Warning! Do not allow any liquid to get inside charger. Never

attempt to open the battery pack for any reason. If the plastic

housing of the battery pack breaks or cracks, return to a

service center for recycling.

State of charge indicator (Fig.B)

The battery is equipped with a state of charge indicator.

This can be used to display the current level of charge in the

battery during use and during charging. It does not indicate

tool functionality and is subject to variation based on product

components, temperature and end-user application.

Checking state of charge during use

u Press the state of charge indicator button (B1).

u The three LEDs (B2) will illuminate, indicating the percent

of charge in the battery. See chart in gure B.

u If LED light does not illuminate, charge battery.

Charger Diagnostics (Fig.E)

Refer to the indicators in gure E for the charge status of the

battery pack.

Bad Battery

If you see a bad battery blink pattern, do not continue

to charge this battery. Return it to a service center or a

collection site for recycling.

Hot/Cold Pack Delay

When the charger detects a battery pack that is too hot

or too cold, it automatically starts a Hot/Cold Pack Delay,

suspending charging until the battery pack has reached an

appropriate temperature. The charger then automatically

switches to the pack charging mode. This feature ensures

maximum battery pack life. A cold battery pack will charge at a

slower rate than a warm battery pack. The pack will charge at

that slower rate throughout the entire charging cycle and will

not return to maximum charge rate even if the pack warms.

Installing and removing the battery pack from the

tool

Warning! Make certain the lock-off button (2) is engaged to

prevent switch actuation before removing or installing battery.

To install battery pack Fig. C)

u Insert battery (14) into battery housing (14b) until an

audible click is heard (Figure. C)

u Ensure battery pack is fully seated and fully latched into

position.

To remove battery pack (Fig.D)

u Depress the battery release button (14a) as shown in

gure D and pull battery pack (14) out of battery housing

(14b).

DUALVOLT 54V Battery Pack (Fig F.)

The DUALVOLT 54V battery pack can be used on 54V &

18V Black+Decker Cordless tools. The battery can recognise

the tool it is inserted into and will run at the relevant power,

providing longer runtime in 18V tools. There is a State of

charge button (14c) which will indicate the level charge at both

54V & 18V.

Setting trimming or edging mode

u The trimmer can be used in trimming mode as shown

in gure N or in edging mode to trim overhanging grass

along lawn edges and ower beds as shown in gure P.

Trimming mode (FIG. L, M)

For trimming, the trimmer head should be in the position

shown in gure N. If it is not:

u Remove the battery from the trimmer.

u Press and hold the head rotate button (9).

u While holding the auxillary handle, rotate the head

clockwise.

u Release the head release button.

u Lift the edge guide (11) into the closed position.

Edging mode (FIG. L, M)

Warning! When being used as an Edger, stones, pieces of

metal and other objects can be thrown out at high speed by

the line. The trimmer and guard are designed to reduce the

danger. However, MAKE SURE that other persons and pets

are at least 30m away. Optimum cutting results are achieved

on edges deeper than 50 mm.

For edging, the trimmer head should be in the position shown

in gure P. If it is not:

u Remove the battery from the trimmer.

u Press and hold the head rotate button (9).

u While holding the auxillary handle, rotate the head

counterclockwise.

u Release the head release button.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker STC5433B Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info