Bedienungsanleitung Blaupunkt CMP312 (Seite 7 von 104) (Deutsch, Englisch)

698863

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

1. On/Off switch

2. Coffee switch

3. Steam switch

4. Cup cushion

5. Drip tray

6. Steam control knob

7. Water tank cover

8. Detachable water tank

9. Cup warmer

10. Steam tube

11. Steam tube jacket

12. Filter holder's mounting point

13. Filter holder handle

14. Stainless steel filter

15. Press bar with spoon

16. Filter holder

17. Barometer

Before first use

It is recommended to rinse the coffee maker before the first use. The coffee maker should also be

rinsed after a longer period of time without use. Refer to the instruction in the “Cleaning and

maintenance” chapter.

NOTE: When water system is empty, the water pump may work louder and device may vibrate more.

This is a common occurrence which will disappear after a given period of time.

Preparation of espresso coffee

1. Turn device on by pressing the On/Off switch [1]. Coffee maker will start to pre-heat, LED will

blink.

2. Choose the right filter [14 ] (for one cup, for two cups) and put it into the filter holder [16]

3. When coffee maker is ready, the LED will stop blinking and shine continuously.

4. Hold the filter holder [16] with filter inside [14] below the mounting point [12] and rinse it

with water to pre-heat it. Press the button “coffee switch” [2] and wait for a few seconds, than

press “coffee switch” again to close the flow of the water.

5. Pour medium ground coffee powder into the filter [14] and pack the coffee gently. Clean the

rim of the filter holder [16] to remove any excess ground coffee.

ADVISE 1. Coffee ground too fine (like for brewed coffee), will block the flow of the water in

the filter. Coffee ground too coarse, will not release the full flavor and aroma of the coffee.

ADVISE 2. If coffee is packed too tightly, the flow of water can be obstructedand may scold

the coffee and cause the drink to have a burned aroma. It may even block the flow of water

totally. If the coffee is packed too loose it will not transfer enough taste and aroma into the

drink.

6. Place the filter holder [16] into the mounting point head [12]. Engravings on the filter holder

must fit in the slots of the filter holder's mounting point. Turn the filter holder all the way to

the right (clockwise).

7. Place cups under the outlets of the filter holder.

8. Press “coffee switch” [2] and wait for the right amount of coffee to pour into the cups

thenpress “coffee switch” [2] again.

Frothing milk

It is advised to froth the milk after the coffee had been prepared as milk frothing mode requires a

higher temperature. After milk frothing it is necessary to wait a minimum of 5 minutes to allow the

device to cool down slightly. If the temperature of brewing is too high, the coffee can be scolded which

will cause the coffee to have a burned and bitter taste and aroma.

Before frothing ensure the volume of milk is adequate in the cup. Milk can double in volume after

frothing, so care should be taken when deciding the volume of milk.

Use a heat-resistant cup for milk frothing. The cup can get very hot during frothing.

1. Turn on the milk frothing mode by pressing “steam switch” [3]. The LED control light will

CMP312

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Blaupunkt CMP312 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info