Bedienungsanleitung Blaupunkt CMP312 (Seite 8 von 104) (Deutsch, Englisch)

698863

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

CMP312

start to blink. When the light starts to shine continuouslythe device is ready to generate

steam.

2. Rinse the steam tube [10] by turning the steam knob [6] anti-clockwise. Steam and some

water will come from the steam wand. Turn off the steam by turning the steam knob into 0

position [6] clockwise.

3. Immerse the steam tube [11] into the cup with cold milk and turn the steam knob [6] anti-

clockwise.

4. To end the milk frothing process turn the steam knob [6] into 0 position (clockwise). Take

out

the steam tube [11] from the cup with milk. Never take the steam tube out of the cup if the

steam knob is not turned off to position 0. Hot steam may cause injuries and scalds.

5. After milk frothing it is advised to put the steam tube [11] into a cup with clean cold water

and rinse the system. After the steam tube is immersed in the cup with water turn the steam

knob [6] anti-clockwise. After few seconds, turn off the steam flow by turning steam [6] knob

clockwise.

6. Turn off the milk frothing mode by press the “steam switch” [3].

Cleaning and maintenance

Rinse the coffee maker's water system

1. Turn device on by pressing the On/Off switch [1]. Coffee maker will start to pre-heat, LED

will

blink.

2. When coffee maker is ready, the LED will stop to blinking and flash constanley.

3. Place the filter holder [16 ] in the mounting point [12 ].To rinse the water system of coffee

maker. Press the button “coffee switch” [2] and wait for a few seconds, then press “coffee

switch” again to close flow of the water.

Regular cleaning after each use

Make sure that coffee maker has cooled down.

1. Remove the filter holder [16] by turning it left (clockwise). Remove the used coffee from

filter

[14] andclean it with water.

2. Take thecup cushion and the drip tray out [4 and 5]. Both elements should be cleaned with

water and a little bit of dishwashing liquid.

3. Never immerse the device in water. The housing should be cleaned with a damp cloth, then a

dried with a dry cloth to remove moisture.

Regular descaling of coffee maker's water system

Depending on the hardness of the water descaling process must be performed every 2-3

months. Regular descaling of the machine protects the device and positively affects the

taste and aroma of the beverage.

WARNING: Lack of descaling causes a significant drop in performance and can lead to

damage of the device. Failure to descale the coffee maker will void the warranty.

Before descaling process, make sure that the device is disconnected from the power source.

1 Fill the water tank with about 500 ml of water, and then add 250 ml of descaling liquid for)

espresso machines (For a correct ratio refer to the manufacturers guide on the preparation

of descaling).

2 Place the filter holder into the filter holding mounting point. Place a cup with a little bit of)

cold water under the steam tube and place an empty cup under the filter holder outlets.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Blaupunkt CMP312 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info