Bedienungsanleitung Bomann KS 2184 (Seite 18 von 28) (Deutsch)

688028

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

• Only install at a location with an ambient tempera-

ture suitable for the climate class of the appliance.

For information on the climate class, please refer

to chapter “Technical Data” or to the rating label

located in the interior or on the rear side of the

appliance.

• Place the appliance on a steady and safe surface.

If the appliance is not horizontally leveled, adjust

the feet accordingly.

• Avoid the installation:

Avoid the installation:Avoid the installation:

Avoid the installation:

- near heaters, next to a stove, direct sunlight or

any other heat sources;

- at locations with high humidity (e.g. outdoors,

bathroom), as metal parts would be suscepti-

ble to corrosion under such circumstances;

- near volatile or flammable materials (e.g. gas,

fuel, alcohol, paint, etc.), in rooms which may

have poor air circulation (e.g. garages).

- Do not expose the appliance any weather.

Assembling the rubber supporting pad

Assembling the rubber supporting padAssembling the rubber supporting pad

Assembling the rubber supporting pad

The screw and rubber supporting pad were send in a

plastic bag, so you can install these accessories

according to the following procedure:

NOTE:

NOTE:NOTE:

NOTE:

• There is no need to install these accessories un-

der normal usage.

• Only under extreme circumstances, when the

cabinet is empty, while load on door with total of

15 kg. This appliance may take risk of tipping.

• Tilt appliance to

find screw hole on

the left of lower

base cover.

• Put the screw into

the hole of rubber

supporting pad.

• Put screw with the

rubber supporting

pad in the hole.

Turn the screw

firmly by a cross

screw driver.

Electrical connection

Electrical connectionElectrical connection

Electrical connection

WARNING:

WARNING:WARNING:

WARNING:

• The installation to the mains supply must conform

to the local standards and regulations.

• Improper connection may cause to an electric

electric electric

electric

shock

shockshock

shock!

• Do not modify the appliance plug. If the plug does

not fit properly to the outlet, let install a proper

outlet by an authorized specialist.

• The accessibility of the power plug must be en-

sured to disconnect the appliance from the power

supply in case of emergency.

CAUTION

AUTIONAUTION

AUTION:

In case of disconnection or power failure:

- Wait for approx. 5 minutes before restarting.

- Check the operation settings.

• Ensure that your mains power corresponds with

the specifications of the appliance. The specifica-

tions are printed on the rating label.

• Connect the mains cable to a properly installed

and earthed wall outlet.

• If the plug after installation is not accessible, a

corresponding disconnect device must be availa-

ble to meet the relevant safety regulations.

Reverse the door opening

Reverse the door openingReverse the door opening

Reverse the door opening

If required, the door opening can be moved from the

right (supplied condition) to the left side.

WARNING:

WARNING:WARNING:

WARNING:

When replacing the door stop, the appliance must be

disconnected from the power supply first.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann KS 2184 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info