476978
14
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
14
CONNECTING TO THE ELECTRICAL MAINS
Before making the connection, check that:
- the mains voltage is as indicated on the nameplate;
- the earth connection is in good working order.
If the socket is not easily accessible, the installation engineer must
provide a switch with a contact breaking gap of 3 mm or more.
If the appliance power lead is not tted with a plug, use an approved
standard type, remembering that:
- the green-yellow wire must be used for the earth connection;
- the blue wire is the neutral;
- the brown wire is live;
- the lead must never touch hot surfaces over about 75 degrees
C;
- replacement leads must be of type H05RR-F or H05V2V2-F of
suitable size (see diagrams in fi g. 2).
- if the appliance is supplied without lead, using type H05RR-F or
H05V2V2-F cable of suitable size (see diagrams in fi g. 2).
IMPORTANT:
The manufacturer declines all liability for damage due to failure to
comply with the regulations and standards in force. Check that the
appliance is correctly connected to the earth (see diagrams in fi g.
2 at the back of the manual).
FOR COOKERS WITH ELECTRIC IGNITION
The correct gaps between the electrode and the burner are shown
in fi gures 5a,5b,6a,6b.
If no spark is generated, do not keep on trying as this might dam-
age the generator.
Possible causes of malfunctions:
- spark plug damp, dirty or broken;
- electrode-burner gap not correct;
- spark plug wire broken or without sheathing;
- spark discharging to earth (to other parts of the cooker);
- generator or microswitch damaged;
- air has built up in the pipes (particularly if the cooker has been
out of use for a long time);
- air-gas mixture incorrect (poor fuel setting).
THE SAFETY DEVICE
The correct gap between the end of the thermocouple sensor and
the burner is shown in fi gures 5a,5b,6a,6b.
To check that the valve is working properly, proceed as follows:
- ignite the burner and leave it to work for about 3 minutes;
- turn off the burner by returning the knob to off position (
);
- after 90 seconds for hob burners, 60 seconds for oven and grill
burners, turn the knob pointer to the "on" position;
- release the knob in this position and move a burning match towards
the burner; IT MUST NOT IGNITE.
Time needed to excite the magnet during ignition: 10 seconds
approx.
Automatic tripping time, after fl ame has been turned off: not more
than 90 seconds for hob burners; not more than 60 seconds for
oven and grill burners.
IMPORTANT:
- Before doing any work inside the cooker, disconnect the mains
plug and shut the gas tap.
- Never use matches to check the gas circuit for leaks. If a specifi c
control device is not available, foam or very soapy water can be
used.
- When re-closing the hob, check that the electrical wires of the
spark plugs (if present) are not close to the injectors, so that they
cannot run across them.
HOW TO USE THE COOKER
VENTILATION
All gas cooking appliances produce heat and moisture in the rooms
where they are installed. Take care to ensure that the kitchen is
well ventilated; keep the ventilation openings unobstructed or install
an extractor hood with fan.In case of intensive or prolonged use,
additional ventilation may be required; open a window, or increase
the extractor fan power.
IGNITING THE HOB BURNERS
- Press the knob and turn it anti-clockwise until it reaches the
symbol on the control panel (maximum fl ame position);
- at the same time, move a burning match towards the burner
head;
- to reduce the ame, turn the knob further in the same direction until
its pointer is against the
symbol (minimum fl ame position).
FOR HOB BURNERS EQUIPPED WITH SAFETY DEVIC
E
- Press the knob and turn it anti-clockwise until it reaches the
symbol on the control panel (maximum fl ame position);
- move a burning match towards the burner, keeping the knob
pressed right down for about 10 seconds;
- then release the knob and check that the burner remains on.
Otherwise, repeat the operation.
IGNITING THE OVEN BURNER
- Open the oven door;
- press the knob and turn it anti-clockwise to the maximum fl ame
position;
- move a burning match towards the hole in the centre of the oven
bottom and press the knob right down (see fi g. 9);
- look through the two holes in the sides of the bottom to check
that the burner has ignited, keeping the knob pressed down;
- after about 10 seconds, release the knob and check that the
burner remains on. Otherwise, repeat the operation.
IGNITING THE GRILL BURNER (GAS GRILL)
- Fit the control knob guard as shown in fi g. 12;
- press the oven knob and turn it to the right until it reaches the
stop;
- move a burning match towards the perforated burner pipe and
press the knob right down (see fi g. 10);
- check that the burner has ignited, keeping the knob pressed
down;
- after about 10 seconds, release the knob and check that the
burner remains on. Otherwise, repeat the operation.
SAFETY DEVICE
Burners equipped with this device have the advantage that they
are protected if they accidentally go out. If this occurs, the supply
of gas to the burner concerned is automatically cut off, preventing
the hazards deriving from a leak of unburnt gas. The gas supply
must be cut off within no more than 60 seconds for the oven and
grill burners or 90 seconds for the hob burners.
FOR COOKERS WITH ELECTRIC IGNITION
All the above applies, except that the match is no longer required; a
spark is obtained by pressing the button on the control panel once
or more, or by pressing the knob of the burner to be ignited.
If electronic ignition is diffi cult with some types of gas, set the knob
on the low (small fl ame) setting.
- For cookers with electric ignition of the oven and grill burners,
ensure the oven door is completely open when these burners are
ignited;
- Do not operate the ignition device for more than 10 seconds when
igniting the oven and grill burners. If the burner has not lit after
these 10 seconds, stop using the device, leave the door open
and wait one minute before trying again to ignite the burner. If the
For the user
GB
Installation
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bompani BO653 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info