Bedienungsanleitung Boretti kookplaten 2012 (Seite 87 von 100) (Deutsch, Englisch, Holländisch, Französisch)

533769

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

brackets to an upright position (Fig. 3a)

Close the door halfway. Without using force, pull

the door slowly towards you (Fig. 4). Attaching

the door is done in reverse order. However, you

must make sure that the little slots underneath

the bracket ﬁt onto the frame of the range cooker.

This may take some practice.

Dismantling the Oven Glass Panel

In order to remove the glass panel from a Boretti

oven door, take the following steps:

Remove the oven door according to the instruc-

tions above. Unscrew the two stainless steel

screws (Fig. 5) at the top and the bottom of the

glass panel, and gently remove the glass panel

(Fig. 6). You can now clean it thoroughly. When

you reinstall the panel, make sure that the stain-

less steel strips clamp the panel properly.

Removing the Inside Panels from the

Oven

In order to remove the inside panels from the

oven, follow these steps:

• open the oven door completely

• remove all racks and baking sheets from the

oven cavity

There are two large screws that you can unscrew

on the sides, after which the side panels can be

easily removed.

Cleaning the Oven Cavity(s)

Wait until the oven has cooled down completely,

then clean it with lukewarm water and a mild

cleaning agent. Never use knives, steel–wool pads

or other abrasive products or objects for cleaning

purposes. This might damage the ﬁnish on the

inside of your oven. Make sure that food spills are

removed after every cooking session, in order to

prevent damage. An additional advantage of regu-

lar cleaning is that there will be fewer unpleasant

odors the next time you use the oven.

Using the Built–In Thermometer

Some range cookers are ﬁtted with a so–called

built–in thermometer. When the oven is cold,

insert the thermometer’s probe into the dish,

and the plug into a special connection that is on

the left side of the oven (Fig. 7). Two values will

appear on the display: The value on the left will

indicate the temperature of the thermometer,

and the value on the right will indicate the pre-

set temperature, which can be adjusted using the

+ and – button on the control panel. When the

preset temperature has been reached, the oven

will switch off and you will be warned by an audio

signal. You can switch the sound off by pressing

on any button on the operating panel.

Remove the thermometer from the connection af-

ter the oven has cooled down. Of course you can

remove the probe from the dish earlier, so that

the dish can be taken from the oven. The oven

thermometer has a reach from 0 – 99°C.

Caution: insert the thermometer into the center

of the dish, and avoid bones or fatty areas in or-

der to achieve a more accurate reading.

See Page 95 for a cooking chart.

Figure 5

Figure 6

Figure 7

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Boretti kookplaten 2012 Seite 87

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info