Bedienungsanleitung Bosch AMW SG (Seite 10 von 156) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

591697

Zoom out

Zoom in

Vorherige Seite

1/156

Nächste Seite

10 | English

F 016 L70 917 | (22.10.13) Bosch Power Tools



Hold bar against branch firmly, do not apply large force - al-

low the pruner to cut through at its natural rate. (see fig. 6)



AMW 10 power unit is fitted with an over-current protection

device. Excessive pressure applied to the pruner chain and

bar in use can cause the protection device to operate.



Reduce force before the branch is completely cut off. You can

get injured, when losing balance and control of the pruner.



Work in steps on thick branches: (1) cut ¼ from below; (2)

cut off from top further outside; (3) cut off the stump at the

stem. (see fig. 6)

Symbols

The following symbols are important for reading and under-

standing the operating instructions. Please take note of the sym-

bols and their meaning. The correct interpretation of the sym-

bols will help you to use the garden product in a better and safer

manner.

Intended Use

This multi-tool attachment can only be operated by the power

unit AMW 10.

The pole pruner is intended for cutting trees and shrubs in pri-

vate use. The pole pruner may not be used for felling trees.

Maintenance and Cleaning



Warning! Switch off, remove plug from mains before ad-

justing or cleaning.

Note:

To ensure long and reliable service, carry out the following

maintenance regularly.

For safe and proper working, always keep the garden product

and the ventilation slots clean.

Regulary check the pole pruner or obvious defects such as loose,

dislodged or damaged saw chain and chain bar, loose fixings and

worn or damaged components.

Check that covers and guards are undamaged and correctly fit-

ted. Carry out necessary maintenance or repairs before using.

If the pole pruner should fail despite the care taken in manufac-

ture and testing, repair should be carried out by an authorised

customer services agent for Bosch power tools.

Note:

Before returning the pole pruner, ensure all oil in the oil

reservoir has been emptied.

In all correspondence and spare parts orders, please always in-

clude the 10-digit article number given on the type plate of the

garden product.

Replacing/Changing the Saw Chain and Chain Bar

Check the saw chain and chain bar according to section

“Kettenspannung einstellen”.

The circular groove of the chain bar will wear particularly on the

lower edge with time. When replacing the saw chain, turn the

chain bar by 180° to allow even wear, thus extending chain bar

life.

Check the drive sprocket

. If it is worn out or damaged due to

strain, have it exchanged by an authorized Bosch after-sales ser-

vice.

Sharpening the Saw Chain

Have your chain sharpened professionally at your authorized

Bosch after-sales service or sharpen the chain yourself using the

Bosch sharpening kit or the Dremel Multi power tool with the ap-

propriate grinder (1453). Observe the sharpening instructions

provided with the sharpening kit.

Checking the Automatic Oiler

Proper functioning of the automatic saw chain oiler can be

checked by running the pole pruner and pointing the tip of the

chain bar towards a piece of cardboard or paper on the ground.

Do not touch the ground with the chain and ensure a safety clear-

ance of 20 cm. If an increasing oil pattern developes, the auto-

matic oiler is operating fine. If there is no oil pattern despite a full

oil reservoir, see section “Troubleshooting” or contact your au-

thorized Bosch after-sales service.

After Use/Storage

Clean the moulded plastic housing of the pole pruner using a soft

brush and clean cloth. Do not use water, solvents or polishes.

Remove all debris, especially from the motor cooling vents.

After 1 – 3 hours of use, remove the cover

, the chain bar

and

the saw chain

, and clean them using a brush.

Clean the area under the cover, the drive sprocket

and the chain

bar assembly from adherant debris using a brush. Clean the oil

outlet

with a clean cloth.

If the pole pruner is to be stored for a longer period of time, clean

the saw chain and the chain bar.

Store the pole pruner in a secure, dry place, out of the reach of

children.

Do not place other objects on the garden tool.

Symbol Meaning

Wear protective gloves

Wear eye protection.

Wear hard hat.

Wear substantial footwear.

Always wear ear protection.

Reaction direction

Movement direction

OBJ_BUCH-1676-002.book Page 10 Tuesday, October 22, 2013 11:57 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch AMW SG Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info