DIGISTAT
INSTALLATION
DIGISTAT / DT10RF RECEIVER
TO CHECK PREVIOUSLY
INSTALLED UNIT
3. Replace the front cover by locating in position and
pushing fully onto the back cover.
To check signal strength on previously
installed and paired units :
1. Press the ‘set’ button 4 times.
2. Press ‘OK’ once.
3. Press the ‘set’ button 5 times. The display will
show ‘SSI and OFF’.
4. Press the ‘+’ button so that the display shows
‘SSI, Antenna and ON’.
5. Press the ‘set’ button so the display shows ‘SSI
and Antenna’.
6. After a few seconds the display will show ‘---’.
7. Remove the batteries from the transmitter and wait
until the display has faded away.
8. Press and hold the ‘+’ button on the transmitter
while re-inserting the batteries and keep the
button depressed until the display shows ‘rF’ .
OPERATING & INSTALLATION
INSTRUCTIONS
DT10RF PROGRAMMER
INSTRUCTION MANUAL
8 716 115 493a (02.2009)
26
