Bedienungsanleitung Bosch GAS 35 L AFC Professional (Seite 19 von 247) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

594768

Zoom out

Zoom in

Vorherige Seite

1/247

Nächste Seite

English | 19

Bosch Power Tools 1 609 92A 0XB | (17.12.14)

Mounting VAC Accessories (see figure C)

The vacuum hose 21 is equipped with a clip system, with

which the VAC accessories (tool sleeve 20, elbow 22) can be

connected.

Mounting the Tool Sleeve

– Mount the tool sleeve 20 onto the vacuum hose 21 until

both snap-fasteners 31 of the vacuum hose can be heard

to engage.

– To disassemble, press both snap-fasteners 31 inward and

pull the components apart.

Mounting Nozzles and Tubes

–Mount the elbow 22 onto the vacuum hose 21 until both

snap-fasteners 31 of the vacuum hose can be heard to en-

gage.

– Afterwards, mount the desired VAC accessory (floor noz-

zle, crevice nozzle, vacuum tube, etc.) firmly onto the el-

bow 22.

– To disassemble, press both snap-fasteners 31 inward and

pull the components apart.

Inserting/Removing a Disposal Bag or Dust

Bag (Dry Vacuuming) (see figures D1 – D2)

For dry vacuuming, a disposal bag 23 or a dust bag (accesso-

ry) can be used. This makes the disposal of the dust easier.

Note: When using a paper filter bag, the automatic filter

cleaning (AFC) (see “Deactivating the AFC”, page 20) must,

and when using a fleece filter bag, should be shut off.

Inserting a Disposal Bag

– Unlock the latches 11 and remove the vacuum lid 10.

– Insert the disposal bag 23 into the container 1 with the fill-

ing opening toward the front.

– Pull the filling opening over the connection flange into the

recess of the connection flange.

– Make sure that the disposal bag 23 faces completely

against the interior sides of the container 1.

– Fold the rest of the disposal bag 23 over the edge of the

container 1.

– Reattach the vacuum lid 10 again and lock the latches 11.

Removing and Closing the Disposal Bag

– Unlock the latches 11 and remove the vacuum lid 10.

– Pull the full disposal bag 23 toward the rear off of the con-

nection flange.

– Carefully remove the disposal bag 23 out of the vacuum

cleaner without damaging it.

When doing this, pay attention that the disposal bag does

not get caught or ripped open against the connection

flange or other sharp objects.

– Pull the cover off of the adhesive strip, close the disposal

bag and tape it shut.

Afterwards, tie off the disposal bag 23 below the filling

opening with the pulled off cover of the adhesive strip.

Replacing/Inserting the Dust Bag (Accessory)

– Unlock the latches 11 and remove the vacuum lid 10.

– Pull off the full dust bag from the connection flange toward

the rear. Close the opening of the dust bag by folding down

the lid. Remove the closed dust bag from the vacuum

cleaner.

– Work the new dust bag over the connection flange of the

vacuum cleaner. Make sure that the dust bag faces com-

pletely against the interior sides of the container 1 over its

full length.

– Reattach the vacuum lid 10 again and lock the latches 11.

Inserting the Rubber Lip (Wet Vacuuming)

(see figure E)

Note: The requirements for the ingress degree (dust

category L) have only been proven for dry vacuuming.

– Carefully pry the brush inserts 27 out of the floor nozzle 28

using a suitable tool.

– Insert the rubber lips 26 into the floor nozzle 28.

Note: The structured side of the rubber lips must face out-

ward.

Attaching an L-Boxx (see figure F)

For transport of the vacuum cleaner and for place-saving stor-

age of VAC accessories and/or power tools, an L-Boxx can be

mounted on the vacuum cleaner lid.

– Mount the L-Boxx onto the retainers 9.

 Do not carry the vacuum cleaner by the carrying handle

of the mounted L-Boxx. The vacuum cleaner is too heavy

for the carrying handle of the L-Boxx. Danger of injury and

causing damage.

Operation

Starting Operation

 Observe correct mains voltage! The voltage of the pow-

er source must agree with the voltage specified on the

nameplate of the vacuum cleaner. Equipment marked

with 230 V can also be operated with 220 V.

 Please inform yourself about the valid regula-

tions/laws for your country concerning the handling of

materials that are hazardous to one’s health.

The vacuum cleaner is suitable for vacuuming and extracting

the following materials:

– Dusts with an exposition limit value > 1 mg/m

The vacuum cleaner may generally not be used in rooms

where the danger of an explosion exists.

To save energy, only switch the vacuum cleaner on when us-

ing it.

To ensure optimal vacuuming performance, always complete-

ly unwind the vacuum hose 21 from the vacuum cleaner lid

10.

Dry Vacuuming

Vacuuming of deposited dusts

– To switch the vacuum cleaner on, set the mode

selector switch 6 to the “vacuuming” symbol.

– To switch the vacuum cleaner off, set the mode

selector switch 6 to the “Off” symbol.

OBJ_BUCH-1746-003.book Page 19 Wednesday, December 17, 2014 2:07 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch GAS 35 L AFC Professional Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info