382842
11
Zoom out
Zoom in
Vorherige Seite
1/68
Nächste Seite
13
Attaching the Saw Blade
To attach the saw blade, insert the bent-out front
connecting piece 11 onto the hook 9.
Then swing the saw blade in the direction of the
arrow and press the tab 12 onto the locking
spring 10 until it latches.
Before switching on, slide the saw blade back and
forth so that it latches onto the drive pin 2.
Only then remove the saw teeth protector 8.
To change the saw blade, place on the saw teeth
protector 8 and press the red SDS button 6. This
causes the tab 12 to spring out of the locking spring.
Remove the saw blade to the rear.
Reversing the Cut-Off Saw Blade
The cut-off saw blade 7 can also be attached
depending on the sawing direction or for a preferred
holding position of the machine (right- or left-hander)
(see Figure on the fold-out page).
For sawing in the other
direction, simply rotate
the cut-off saw blade in
the direction of the arrow
and attach as described
above.
Reversing the Flush Saw Blade
The flush saw blade 13 can be attached to the
machine depending on the desired sawing direction
(see Figure on the fold-out page).
For sawing in the other
direction, simply rotate
the flush saw blade in the
direction of the arrow and
attach as described
above.
Always use the correct supply voltage!
The voltage of the power source must agree with the
value given on the nameplate of the machine.
Machines designated for 230 V can also be operated
with 220 V.
Switching On/Off
Switching on: Slide the on/off switch 3 to the front
and press down at the front to latch.
Switching off: Press the rear of the on/off switch 3,
the switch springs back to the off
position.
Stroke Rate Selection (PFS 280 E Set)
The stroke rate can be set in steps, also while working,
with the stroke rate selector 4.
.
The optimum stroke rate depends on the material and
must be determined by trials in each case.
1
2
9
11
12
10
2
6
B
Putting into Operation
Application Position
Soft wood 3 – 6
Hard wood 4 – 6
Plastic 1 – 6
A
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch pfs 280 e wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info