Bedienungsanleitung Bosch PMF 10.8 LI (Seite 18 von 117) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

591462

Zoom out

Zoom in

Vorherige Seite

1/117

Nächste Seite

18 | English

1 609 92A 0SE | (30.10.14) Bosch Power Tools

Selecting the Sanding Sheet

Depending on the material to be worked and the required rate of material removal, different sanding sheets are available:

Dust/Chip Extraction

 Dusts from materials such as lead-containing coatings,

some wood types, minerals and metal can be harmful to

one’s health. Touching or breathing-in the dusts can cause

allergic reactions and/or lead to respiratory infections of

the user or bystanders.

Certain dusts, such as oak or beech dust, are considered

as carcinogenic, especially in connection with wood-treat-

ment additives (chromate, wood preservative). Materials

containing asbestos may only be worked by specialists.

– As far as possible, use a dust extraction system suitable

for the material.

– Provide for good ventilation of the working place.

– It is recommended to wear a P2 filter-class respirator.

Observe the relevant regulations in your country for the mate-

rials to be worked.

 Prevent dust accumulation at the workplace. Dusts can

easily ignite.

Connecting the Dust Extraction (see figure A)

Remove the application tool/accessory when mounting the

dust extraction 18 (accessory).

If required, assemble the parts of the dust extraction 18 as

shown in the figure. Position the assembled dust extraction

onto the machine via the tool holder 7. Turn the dust extrac-

tion in such a manner that the cams of the dust extraction en-

gage into the corresponding recesses on the housing. Fasten

the dust extraction to the machine with the retaining clip 16

as shown in the figure.

Pay attention that the felt ring 15 is undamaged and faces

tightly against the sanding plate 12. Replace a damage felt

ring immediately.

Place a vacuum hose 19 (accessory) onto the vacuum con-

nection 17. Connect the vacuum hose 19 with a vacuum

cleaner (accessory). An overview for the connection of vari-

ous vacuum cleaners can be found at the end of these instruc-

tions.

The vacuum cleaner must be suitable for the material being

worked.

When vacuuming dry dust that is especially detrimental to

health or carcinogenic, use a special vacuum cleaner.

Operation

Starting Operation

Inserting the battery

 Use only original Bosch lithium-ion batteries with the

voltage listed on the nameplate of your power tool.

Using other batteries can lead to injuries and pose a fire

hazard.

Note: Use of batteries not suitable for the machine can lead to

malfunctions of or cause damage to the power tool.

Insert the charged battery 2 into the handle until it can be felt

to engage and faces flush against the handle.

Switching On and Off

To switch on the power tool, push the On/Off switch 5 toward

the front in the direction of the “1” on the switch.

To switch off the power tool, push the On/Off switch 5 to-

ward the rear in the direction of the “0” on the switch.

To save energy, only switch the power tool on when using it.

The lithium-ion battery is protected against deep discharging

by the “Electronic Cell Protection (ECP)”. When the battery is

empty, the machine is switched off by means of a protective

circuit: The inserted tool no longer rotates.

Sanding disc Material Application Grain size

Red quality

– All wooden materials

(e. g., hardwood, soft-

wood, chipboard, build-

ing board)

–Metal materials

For coarse-sanding, e. g. of rough, unplaned beams

and boards

coarse 40

For face sanding and planing small irregularities

medium 80

100

120

For finish and fine sanding of wood

fine 180

240

320

400

White quality

–Paint

–Varnish

–Filling compound

–Filler

For sanding off paint

coarse 40

For sanding primer (e. g., for removing brush dash-

es, drops of paint and paint run)

medium 80

100

120

For final sanding of primers before coating

fine 180

240

320

OBJ_BUCH-1170-005.book Page 18 Thursday, October 30, 2014 8:12 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch PMF 10.8 LI Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info