112553
7
Zoom out
Zoom in
Vorherige Seite
1/56
Nächste Seite
7
Before using your shirt ironer
Adjusting the connection current:
The appliance is plugged in. The shirt ironer is
off and the programme selector switch 4, Fig.
1, is set to “0”. The button band is fully lifted.
Press the and the start/stop buttons in at
the same time and keep them pressed in.
Three sound signals are emitted to confirm
the operation.
Digital screen 5, Fig. 1, displays the current
the appliance is set to.
Press “Start/stop“. The screen displays the
connection current setting. Press the same
button again to change the current.
Three sound signals are emitted to confirm
the operation.
Press when the current you wish to
work at is displayed on the screen; the shirt
ironer switches itself off and the new setting
is stored in the memory.
The ironing time is longer with the 10-Amp
setting.
The 16-Amp setting is recommended for
enhanced performance.
Adjusting the signal
Sound signals are emitted to indicate that a
specific circumstance has taken place in the
programme.
Change in the connection current setting.
End of ironing and airing cycle.
Adjusting the indicator light
The light flashes 10 times when the
appliance is already at its lifted position
when plugged in.
The light flashes 10 times when the
appliance is lifted from its down position
when already plugged in.
The light flashes to remind you to press
the button at the start of use in order to
initiate preheating and thereby reduce shirt
drying time.
The light lights up when the appliance
is working.
The start / stop light and the light light
up when the appliance is blowing air, in any
cycle.
When the appliance is on pause, the start /
stop light flashes for the 30 seconds that
this function lasts.
Adjusting the size
The size of the ironing dummy is based on
European shirt sizes. The size can be
adjusted between sizes 35 and 50. These
sizes coincide with American sizes XS and
4XL. In the case of blouses, sizes 36/38 to
50/52 (S to XXL) can be used.
The ironing dummy can be adapted to
different cuts (e.g. tapering, blouse cuts) by
adjusting the size. This is done by adjusting
the 3 adjustment cords 16, Fig. 2. To adjust
the size, start by adjusting the top cord. The
volume of the ironing dummy cannot be
reduced when inflated.
2 button arm straps are supplied for ironing
short-sleeved shirts, Fig. 3.
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch THB 1500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info