697129

Bosch TR1100 - 18B Seite 10

10
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
Special accessories
TR1100 – 6 720 876 016 (2018/04)
10
4 Special accessories
• BZ45U20 Pipe set: for use of the continuous-flow heater as an under
sink appliance.
• Intermediate terminal block BZ45Z20M: Required when the mains
connecting cable is fed in through the bottom access hole 14a.
• Priority switch (load shedding relay) BZ45L21: for operation with
a priority circuit.
• Mounting kit BZ45K24M: for surface mount installation.
• Truncated connecting piece sealed at rear for water connection from
below (e. g. cold water connection via fitting mounted below heater):
5 Operating instructions
Please read and observe the detailed safety instructions at the start
of these instructions!
• Important: The appliance may never be exposed to frost!
WARNING:
Risk of electric shock!
Switch off the mains voltage supply immediately if a fault occurs.
• Immediately shut off the cold water supply to the appliance should
it leak.
5.1 Getting to know your appliance
The continuous-flow heater heats the water as it flows through
the appliance. The appliance only consumes power during this period.
This appliance can supply hot water to taps in several different locations.
It should be installed close to the tap that is used the most frequently.
This will enable you to reduce energy consumption.
5.2 Operating the appliance
The continuous-flow heater has two power settings:
"eco" Economy setting – two thirds power
"comfort" Intensive setting – full power
The "eco" setting is ideal for:
"comfort" setting should be used where a higher temperature or a larger
volume of water is required, e. g.
If you are using a thermostat-controlled mixer tap, set the heater to
"comfort".
1. Set the heater to either "eco" or "comfort", as required.
2. Turn on the hot-water tap.
The continuous-flow heater switches on automatically and heats
the water as it flows through the appliance.
The heater switches off again when you turn off the tap.
Increasing the water temperature
When the tap is turned on fully, it is possible that the heater capacity
is not sufficient to heat the water to the required temperature.
• Slightly close the hot-water tap. The water flows through the
appliance more slowly and reaches a higher temperature as a result.
Decreasing the water temperature
• Mix with cold water.
Note about operation
When a hot-water tap is turned on by only a small amount,
the continuous-flow heater operates at half power regardless of which
setting ("eco", "comfort") has been selected.
When a hot-water tap is turned on fully, the appliance operates
at the maximum level of power that corresponds to whichever setting
has been selected.
Saving energy
• Please use economy setting “eco” as often as possible.
To minimise energy consumption when turning off the hot water:
• Turn off the hot-water tap slowly in order to use the residual heat
of the continuous-flow heater.
• This also prevents the water temperature from briefly increasing
above the preselected temperature if the hot water tap is turned
on again within the next few minutes.
To obtain particularly uniform hot-water temperatures,
it is recommended to use thermostat-controlled mixer taps.
The thermostat-controlled mixer tap must be suitable for hydraulically
controlled continuous-flow heater.
Winter operation
NOTICE:
It is possible in winter that the supply temperature of the water
is reduced and the required outlet temperature is no longer achieved.
• In order to compensate for this temperature reduction, please reduce
the water quantity on the tap until the required water temperature
is achieved.
5.3 Cleaning
• Simply wipe the appliance with a damp cloth. Do not use acidic
or abrasive cleaning materials.
NOTICE:
It is normally not necessary to descale the appliance. However,
extremely hard water and the frequent flows of very hot water can cause
the appliance to scale up. In this case please contact our after-sales
service.
Elbow joint, “cold” (right) Order no. 056169
Elbow joint, “hot”, (left) Order no. 255568
Wash basin
Shower
Bidet
Dishwashing
Cleaning
Bath tub
… 10 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch TR1100 - 18B wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info