Bedienungsanleitung Bosch Tronic 3500 TO (Seite 11 von 52) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

780665

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Technical data

Tronic 2500 TO | Tronic 3500 TO | Tronic Store Advanced – 6 720 876 005 (2021/07)

Undersink appliances TR3500TO 5 T and TR3500TOR 5 T

(Fig. 6)

• Fit the taps if required (A1 and A2).

• Insert the seals (B1).

• Ensure the axial ﬁt of the connection pipes in the nozzles.

• Place the union nuts on the thread and tighten them by hand (B2).

• Tighten the screw ﬁtting (C). Counter the threaded nozzles on the

warm water heater with a wrench

• After the unit has been used to heat water a few times, retighten the

screw ﬁtting.

Oversink appliances TR2500TO 5 B (Fig. 7)

• Install the mixer if required (D1 to D3).

• Insert the pipe connections to the mixer with seals (E). Ensure the

axial ﬁt of the connection pipes in the nozzles.

• Insert the seals on the pipe connection (F1).

• Suspend the appliance (G).

• Place the union nut (F2) on the thread and tighten it by hand.

• Tighten the screw ﬁttings (H1 and H2). Counter the threaded nozzles

on the warm water heater with a wrench (H1).

2.5 First start-up

2.5.1 Electrical connection

•Important: Do not insert the plug into the mains socket yet.

• Fill the appliance with water ﬁrst. Water must ﬂow from the ﬁtting.

• Only then insert the plug into the mains socket.

Note: If the appliance is not ﬁlled with water, the resettable safety

temperature limitation will trip!

2.5.2 Checking the heating

• Turn the rotary selector switch to “3” (approx. 85 °C).

• Monitor the heating process until the pilot lamp switches off after

approx. 12–18 minutes.

• Check the temperature.

CAUTION:

If the safety temperature limitation has switched off the small water

heater, unplug the mains plug, open the warm water tap and allow

approx. 4 litres of water to ﬂow. Then plug the mains plug back in.

The appliance is ready again for operation.

2.5.3 Limitation of the water temperature

The temperature of the water leaving the tap for the small water heater

can be mechanically set to stage “1” (approx. 38 °C) or stage “eco”

(approx. 60 °C) (see “Operation”, page 13).

Conserving energy

• Set the rotary selector to “eco” to conserve energy.

• Hand over the installation and operating instructions to the user and

explain how the appliance operates.

3Technical data

Type TR3500TO 5 T

Undersink

TR3500TOR 5 T

TR3500TO 5 T

Undersink

TR2500TO 5 B

Over-sink

TR2500TO 5 B

Over-sink

Rated output [kW] 2.2 1.8 2.2 1.8

Rated capacity [l] 5.0 5.0 5.0 5.0

CLICKFIX plus installation technology 

Pressure stop   – –

Drip stop  ––

Mixed water quantities 40 °C

(15°C/85°C)/(15°C/85°C) [l] 9.5/14 9.5/14 9.5/14 9.5/14

Variable temperature adjustment up to [°C] 85 85 85 85

Stand-by power consumption at 65 °C/24 h [kWh/d] 0.18 0.18 0.18 0.18

Electrical connection [V] 230 230 230 230

Heat-up time to 60 °C

( temperature 12 °C) [min] 8 9 8 9

Fuse protection [A]10101010

Water connection ["] 3/8 3/8 1/2 1/2

Maximum ﬂow [l/min]5555

Cable length [m] 0.6 0.6 0.6 0.6

Dimensions (Height×Width×Depth) [mm] 435×270×240 435×270×240 435×270×240 435×270×240

Weight, ﬁlled [kg] 7.7 7.7 7.7 7.7

Subject to change without notice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch Tronic 3500 TO Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info