600511
37
Zoom out
Zoom in
Vorherige Seite
1/52
Nächste Seite
Faults and what to do about them. en
37
Information on the display panel
Display Cause/Remedy
- P - and ÿ The door is unlocked. It is possible to add laundry.
- P - The temperature is too high. Wait until the temperature drops.
The water level is too high. It is not possible to add laundry. Close the door
immediately, if necessary. Press the A button to continue the programme.
ÿ flashes Laundry may be caught. Open and close the door again and press the A
button.
If necessary, push the door closed or remove some laundry and then push it
closed again.
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
ù flashes The detergent drawer has not been pushed in completely. Push the detergent
drawer in correctly.
r lights up Turn on the tap fully,
Supply hose kinked/trapped,
The water pressure is too low. Clean the filter. ~ Page 35
E:18 The drain pump is blocked. Clean the drain pump. ~ Page 34
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~ Page 35
E:23 There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services. ~ Page 40
E The childproof lock is activated – deactivate it. ~ Page 25
Å lights up Too much foam has been detected and an additional wash cycle has been
activated. Add less detergent to the next washing cycle with the same load.
The indicator light for
the Drum Clean
programme* flashes
*depending on the
model
Run the Drum Clean 90 °C programme or a 60 °C programme to clean and care
for the drum and the outer tub.
Notes
Run the programme without laundry.
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergent designed for woollens or delicates.
Switching the information signal on/off ~ Page 31
Other displays Switch off the appliance, wait for five seconds and then switch it on again. If the
display appears again, call customer services. ~ Page 40
37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

bosch-waw28640

Suche zurücksetzen

  • Es erscheint E 81 mit Signalton.
    In meiner Betriebsanleitung gebt es dazu keinen Hinweis. Eingereicht am 28-4-2024 08:31

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch WAW28640 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Bosch WAW28640

Bosch WAW28640 Bedienungsanleitung - Deutsch - 56 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info