Bedienungsanleitung Bose B2 basmodule (Seite 36 von 146) (Englisch)

571290

Zoom out

Zoom in

Vorherige Seite

1/146

Nächste Seite

Advice for use

Never burn wood with an open door.

Regularly burn wood with intense roaring fires.

If you frequently have low intensity fires, tar

and creosote may be deposited in the chimney

. Tar and creosote are highly combustible

substances. Thicker layers of these

substances might catch fire when the

temperature in the chimney increases

suddenly and steeply. Therefore it is

necessary for the fire to regularly burn very

intensely, so that layers of tar and creosote

disappear.

Low intensity fires also cause tar deposits on

the stove window and door.

When the outside temperature is not very low,

it is better to burn wood intensely for a few

hours instead of having a low intensity fire for a

long period of time.

Control the air supply with the secondary air inlet.

The secondary air inlet not only supplies air to

the fire but to the glass as well, so that it does

not get dirty so quickly.

Open the primary air inlet for the time being if the air

supply by the secondary air inlet is inadequate or if

you want to fan the fire.

It is better to add a small amount of logs regularly

than to add many logs at the same time.

Regularly adding small amounts of brown coal

briquettes or anthracite coal is better than adding a

large amount of brown coal briquettes or anthracite

coal at once.

Extinguishing the fire

Do not add fuel and just let the fire go out. If a fire is

damped down by reducing the supply of air, harmful

substances will be produced and released. Therefore,

let the fire go out naturally. Keep an eye on the fire

until it has gone out. When the fire has died

completely, all air inlets can be closed.

Removing ashes

After the brown coal briquettes and anthracite coal

has been burnt, a relatively large amount of ash is left

over. Therefore, remove any excess ash frequently.

After the wood has been burnt, a relatively small

amount of ashes is left over. This bed of ashes is a

good insulating layer for the bottom of the fire

compartment and improves combustion. Therefore,

you can leave a thin layer of ashes on the bottom of

the fire compartment.

However, the air supply through the bottom of the fire

compartment must not be impeded and no ash should

be allowed to accumulate behind a cast iron inner

plate. Therefore, remove any excess ash frequently.

The ash should never reach the underside of the grate.

This will cause the grate to overheat and be damaged.

1. Open the ash door of the appliance.

2. With appliance 750GH: remove the ash removal

port and use the supplied scraper to sweep the

excess ash into the ash pan..

3. Remove the ash pan using the "cold hand"

provided and empty the ash pan; see next figure.

4. Install the ash pan and close the ash door of the

appliance.

Fog and mist

Fog and mist hinder the flow of flue gases through the

flue. Smoke can blow back and cause a stench. If it is

not strictly necessary, it is better not to use the stove

in foggy and misty weather.

Subject to change because of technicalimprovements

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bose B2 basmodule Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bose B2 basmodule

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info