Bedienungsanleitung Boston Acoustics Horizon Solo XT (Seite 12 von 88) (Deutsch, Englisch, Französisch, Italienisch, Spanisch, Schwedisch)

741648

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

Sleep Function

You can set the Solo XT to play a radio station for up to 90 minutes. After the speci ed time the Solo XT shuts

o . You can use the Sleep Function with one of the radio sources or with the Aux input.

Use the MODE/INFO control to select the source you want. Set the volume level where you want it.

Turn the MODE/INFO control to highlight “Setup Options”, then press the control. The “Setup Options”

menu appears in the display.

Turn the MODE/INFO control to highlight “Sleep” then press the control. (The “Sleep” menu selection is

not on the initial “Setup Options” menu. Turn the MODE/INFO control until it appears. See the display

illustrations on page 6.) The highlight box around “O ” will  ash.

Turn the MODE/INFO or TUNE control clockwise to set the amount of

time delay you want. You can select from 5 to 90 minutes in 5 minute

increments. Press the control.

The display example to the right shows the Sleep delay set for 20 minutes.

Turn the MODE/INFO control to highlight “Exit” and press the control. Or wait a few seconds and the

display will “time out” automatically.

The display will go to its default mode – either source or time display,

depending on what you have chosen. The “S” Sleep icon will appear at the

bottom center of the display.

This display example shows the “S” Sleep icon. The radio is tuned to 104.75, which is

Preset 10. The time is 10:40 PM and Alarm 2 is turned on.

To check the remaining sleep time, touch the metal trim ring. The display will show the amount of sleep time

remaining. Touching the metal trim ring again while the sleep time is displayed decreases the sleep time

to the next lower step – 20 minutes, 15 minutes, 10 minutes, etc. Each additional touch decreases the sleep

time by 5 minutes.

Notes: To cancel the Sleep delay before it has  nished press the Power/Volume button to turn the Solo XT

o .

Audio Controls

Usually the Solo XT will sound best without any adjustments to the audio controls. But Bass and Treble

adjustments are available if you want to adjust the tone balance.

Turn the MODE/INFO control to highlight “Setup Options’”. Press the control.

Turn the MODE/INFO control to highlight “Audio”. Press the control. (The

“Audio” menu selection is not on the initial “Setup Options” menu. Turn

the MODE/INFO control until it appears. See the display illustrations on

page 6.) You’ll see the display shown to the right.

Turn the MODE/INFO control to highlight either “Bass” or “Treble”. Press the

control. The highlight box around the setting number will  ash.

Turn the MODE/INFO or TUNE control to adjust the setting. Press the

control to set adjustment. Or wait a few seconds and the menu will “time

out” automatically setting the adjustment.

In this example the Bass is set to –2

and the Treble is set to +1

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Boston Acoustics Horizon Solo XT Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info