Bedienungsanleitung Braun 8360cc -5795 (Seite 13 von 70) (Alle Sprachen)

695426

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

• If you regularly clean the shaver under water,

apply a drop of light machine oil on top of the

Foil & Cutter cassette once a week.

The shaver needs to be cleaned under running

water after each foam or gel usage!

Cleaning with a brush

• Switch off the shaver. Remove the Foil & Cutter

cassette (1) and tap it out on a flat surface. Using

the brush, clean the inner area of the pivoting

head. Do not clean the cassette with the brush as

this may damage it!

Clean & Charge Station (C & C)*

The Clean & Charge Station has been developed for

cleaning, charging, lubricating and storing your

Braun shaver.

12 Station power socket

13 Lift button for cartridge exchange

14 Station-to-shaver contacts

15 Clean & Charge Station display

15a Level indicator

15b Status light

15c Cleaning program indicators*

16 Start button

17 Cleaning cartridge

* not with all models (see display box)

C & C Installation

• Remove the protection foil from the C & C display.

• Press the lift button (13) at the rear side of the

C & C to lift the housing.

• Hold the cleaning cartridge (17) down on a flat,

stable surface (e.g. table).

• Carefully remove the lid from the cartridge.

• Slide the cartridge from the rear side into the base

of the station until it snaps in.

• Slowly close the housing by pushing it down until it

locks.

• Using the power supply (10), connect the station

power socket (12) to an electrical outlet.

C & C Usage

Important: The shaver needs to be dry and free

from any foam, gel or soap residue!

• Insert the shaver in the C & C upside down, with

the front showing and head lock (3) released.

• The contacts (7) on the back of the shaver need to

align with the contacts (14) in the C & C. Push the

shaver backwards in the correct position. A beep

sound confirms that the shaver sits properly in the

C & C.

• Only C & C with cleaning program selection: The C

& C analyses the hygiene status. The status is

shown by the cleaning program indicators (15c) in

the C & C display (15).

Charging the shaver in the C & C

Charging will start automatically when the shaver

has been inserted properly.

Cleaning the shaver in the C & C

When the cleaning indicator lights up on the shaver

display, insert the shaver into the C & C, as de-

scribed above.

Cleaning programs (not with all models)

short / economical cleaning

normal level of cleaning

intensive cleaning

Each cleaning program consists of several cycles,

where cleaning fluid is flushed through the shaver

head.

Automatic cleaning

Start the cleaning process by pressing the start

button (16). If status light (15b) does not shine (C & C

switches to stand-by after ca. 10 minutes), press

start button twice. Otherwise, cleaning will not start.

Depending on your model and / or program

selected, the cleaning time takes up to 3 minutes.

During this time the status light (15b) blinks.

After cleaning and charging is completed, all

indicators turn off.

Leave the shaver in the C & C for drying. It takes

several hours until remaining moisture evaporates

depending on the climatic conditions.

Removing the shaver from the C & C

Hold the C & C with one hand and tilt the shaver

slightly to the front to release it.

Cleaning cartridge / replacement

When the level indicator (15a) lights up permanently

red, the remaining fluid in the cartridge is sufficient

for about 3 more cycles. When the level indicator

blinks red, the cartridge needs to be replaced –

about every 4 weeks when used daily.

After having pressed the lift button (13) to open the

housing, wait for a few seconds before removing the

used cartridge to avoid any dripping. Before

discarding the used cartridge, make sure to close

the openings using the lid of the new cartridge,

since the used cartridge will contain contaminated

cleaning solution.

The hygienic cleaning cartridge contains ethanol or

isopropanol (specification see cartridge), which

once opened will naturally evaporate slowly.

Therefore, each cartridge, if not used daily, should

be replaced after approximately 8 weeks. The

cleaning cartridge also contains lubricants for the

shaving system, which may leave residual marks on

the outer foil frame and the cleaning chamber of the

91818830_83XXcc_W&D_MN_Type_5795.indd 1391818830_83XXcc_W&D_MN_Type_5795.indd 13 09.05.18 09:1509.05.18 09:15

Business Use - P&G AUTHORIZED POA-00044767 Rev 001 Effective Date 2018-05-14 Printed 2018-07-25 Page 13 of 72

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Braun 8360cc -5795 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info