At the base unit:
• Press and hold down the green paging
button until you hear the beeps (after about
10 seconds).
At the handset:
• Press and hold down the button number 2,
3 or 4 to specify the base unit number.
• At the same time, hold down the PWR button
until the display shows.
• Enter the system code.
(Factory setting is 0000.)
• Press the # button the beep stops after a
few seconds, the display shows all available
handset numbers.
• Enter the single digit internal number – from
2 to 6 – for the additional handset.
• It is now registered.
To set/clear the display of the base unit
number on a handset
The factory setting is to display the number.
This is useful if your handset is connected to
more than one base unit.
• Press the STO button.
• Press the 3 button then the 6 button.
The current setting is displayed.
• Press the 1 button to display the base unit
number.
or
• Press the 0 button if you do not want to
display the base unit number.
• Press the STO button to confirm.
If the maximum number of handsets are already
registered with the base, three dashes will appear in
the display after you enter the system code.
27
Operating with additional
base unit
