To set your handset for automatic base
selection
If you are moving around, and likely to lose
contact with your base unit, your handset can
be made to automatically switch to the first
available base unit. If this is set and you are in
the area where the signals of two base units
are overlapping, your handset will select the
strongest signal.
The handset must be switched
ON
• Press the STO button.
• Press the INT button. Display shows the
numbers of the base stations at which the
handset is registered.
• Press the 0 button to set automatic selection.
• Press the STO button to confirm. The
handset will now select the base unit offering
the strongest signal. Display will show the
base unit selected (unless de-activated – see
page 27 to set/clear the display of the base
unit number on a handset).
To set your handset for manual base
selection
You can select a base unit through which you
want your handset to operate.
Your handset will search for the base unit for
30 seconds. If the base unit cannot be found,
the handset then looks for a base unit with the
next best signal.
This setting is recommended where there is an
overlap between two or more base units.
The handset must be switched
ON
• Press the STO button.
• Press the INT button. Display shows the
numbers of the base stations at which the
handset is registered.
• Press the number button – from 1 up to 4 –
for the base unit you want to select.
• Press the STO button to confirm.
28
Operating with additional
base unit
