Bedienungsanleitung Cadel IDRON 16-22 AIRTIGHT (Seite 29 von 40) (Englisch)

815161

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

IDROSTUFE

14.17 ALARM RESET

NEVER open the stove door while it is starting up initially or switching off, as the pellets are

still burning at this point and there may be volatile substances.

ATTENTION!

If smoke flows into the room from the appliance or the flue during operation or initial igni-

tion, switch off the device, air out the room, and immediately contact the installation/custo-

mer service technician.

To reset the alarm, you must hold down key 1 (ESC) for a few seconds. The stove performs a check to determine whether what

caused the alarm is still present.

If this is the case, the alarm will be shown again, otherwise the stove will switch OFF.

If the alarm persists, contact a service centre.

15 ROUTINE MAINTENANCE

15.1 INTRODUCTION

For a long working life of the stove, have a periodic cleaning of the stove as described in the following paragrafs.

• Fume outlet pipes (fume conduit + chimney flue + chimney pot) must always be cleaned, scrubbed and checked by an autho-

rized technician in compliance with local regulations, with the instructions of the manufacturer and those of your insurance

company.

• If there are no local regulations and no instruction from your insurance company, it is necessary to have your fume pipe, chim-

ney flue and chimney pot cleaned at least once a year.

• It is also necessary to have the combustion chamber, motors and fans cleaned and to have the gaskets and the electronical

elements checked at least once a year.

All these operations must be planned in time with your Autorized Technical Assistance Service.

• After a long ineffective time, before turning on the stove check if there are obstructions in the fume exhaust.

• If the stove had been using continuously and intensely, the whole system (chimney included), must be cleaned and checked

more frequently.

• In case of replacement of damaged pieces please ask for the original spare part at the Autorized Retailer.

15.2 BEFORE EACH STARTUP

Clean the ash and any deposits in the brazier that could clog the air passage holes.

If the pellets in the hopper finish, unburned pellets may accumulate in the brazier. Always empty the residue in the brazier before

startingup.

Check that there is no excessive ash accumulated under the burning pot compartment. If it exceeds 2 cm of height, we recommend

sucking it.

REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE START-UP AND OPTI-

MAL OPERATION OF YOUR PELLET PRODUCT.

For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on

the bottom.

If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating conditions of the

component.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadel IDRON 16-22 AIRTIGHT Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info