Bedienungsanleitung Cadel Kriss (Seite 19 von 72) (Englisch, Holländisch)

694395

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

NICE - MIRIAM - CRISTAL - PRETTY - KRISS - MARY - TECNA - EVO

POS. REFERENCE DESCRIPTION

4 STAND-BY MODE

It activates a function which, if the set ambient temperature has been exceeded for more

then 10 minutes, start the switching off phase up. If the ambient temperature has fall at

more than 2°C, the stove will restart automatically up, starting from START UP page 19.

Press once P3 key and with P1 and P2 keys put in “OFF” or “ON”. CAUTION: do not activate

if CHRONO function is active!

BUZZER MODE

(audio alarm)

Press once P3 key and with P1 and P2 keys put in “OFF” or “ON”.

6 INITIAL LOAD

When the stove has its rst ignition, the auger is completely empty. If it should be necessary

do a precharge by pressing P3 key, then P1 key for starting up and P4 key for stop.

7 STOVE STATE

It shows all parameters connected to the stove state: this is a menu for the Authorized

Techinician

8 TECHNICA SETTING Only for the Authorized Technician.

9 FLAME SETTING It enables to set the ame dipending on the draught of the chimney ue.

12.4 START UP

We remind you that the rst ignition must be carried out by a specialized and authorixed technician who will

check that all is installed in compliance with current regulations and checks the efciency.

• If inside the combustion chamber there are booklets, manuals, etc..., remove them.

• Check if the door is correctly closed.

• Check if the stove is correctly inserted in the electric socket.

• Before switching the stove on, assure you the burning pot is clean.

• To start the stove up, keep pressed P4 key for an instant till it will be shown “START” and “PREHEAT WAIT”: the

preheating of the ingnition resistance starts. After 2 minutes about, it will be shown “PELLET LOAD, WAITING FIRE”,

in this phase the auger loads the pellet and the heating of the resistance continues. When the temperature is

sufciently high (after 7-10 minutes about), the ignition is considered as happened and on the display shows

“FIRE PRESENT”.

• Completed the phase “FIRE PRESENT”, the control unit enter the “WORK” phase showing the set caloric

power and ambient temperature. It is in this phase that P5 and P6 keys settle the stove power from 1 to 5. If

the value of the ambient temperature exceeds the limit set on the keyboard on the temperature setting, the

caloric power will be carried at the minimum showing “WORK, MODULAT”. When the ambient temperature

turns back below the set temperatur, the stove turns back to the set power.

12.5 STOVE ADJUSTMENT

The stove is adjusted according to the chimney ue and used pellets datas, as per technical characteristics (see

FEATURES page 34). If the datas do not correspond, the authorized technician can adjust the stove.

• If the pellet is small in size and with a greater caloric power, (for example: encrusted burning pot), the pellet

drop must be decreased from the menu “FLAME SETTING”, press P3 “PELLET TYPE”, press P3 again “PELLET

LOAD” and with P2 key decrease the pellet quantity from -1 (which is -2%) till -9 (which is -18%).

• If the chimney ue has a lower draught (for example: weak ame, sooty glass) the revolutions of the geared

motor must be increased from the menu “FLAME SETTING”, press P5 “CHIMNEY TYPE”, press P3 “FUME-EXH

CHIMNEY” and with P1 key increase the fume fan revolutions from +1 (which is +5%) till +9 (which is +30%).

• If the chimney ue has a greater draught (for example: because of pellets fall on the burning pot) decrease

the fume fan revolutions from -1 to -9.

Pay attention if the value is positive or negative..

12.6 AIR REGULATOR

The stove is provided with a back air regulator and must have the following parameters (written also on the back

of the stove):

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadel Kriss Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadel Kriss

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info