Bedienungsanleitung Cadel Kriss (Seite 20 von 72) (Englisch, Holländisch)

694395

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

NICE - MIRIAM - CRISTAL - PRETTY - KRISS - MARY - TECNA - EVO

Fig. 27 - Air regulator

• Air regulator entrance 12 mm to nominal power with a chimney ue of 11 Pa.

12.7 FAILED IGNITION

If the pellets do not burn, the failed ignition will be indicated by the alarm “FAILED IGNITION”.

• If the room temperature is lower than 10°C, the plug is not able to bear the ignition stage. To support it please

insert some pellets in the burning pot and a piece of burning relighter igniter material on the pellets (for

example relighters cubes).

After a failed ignition the burning pot must be empty from the amassed pellets, before

starting the stove up again.

• Too much pellets in the burning pot, or humid pellet, or sooty burning pot make ignition difcult and create

dense white smoke which is harmful to health and can cause explosions on the combustion chamber. It is

therefore necessary not to stand in front of the stove during ignition stage if dense white smoke is present.

If after some months the ame appears weak and/or orange colored or the glass tends

to blackens and the burning pot to become encrusted, clean the stove, clean the fume

conduit and the chimney ue.

12.8 POWER FAILURE

• After a black-out lower than 5 seconds, the stove turns back to the power which was settled.

• After a black-out of more than 5 seconds, the stove enters the “COOLING WAIT” phase. Completed this

phase, it starts automatically up with the different phases (see START UP page 19).

12.9 TEMPERATURE SETTING

• To modify the ambient temperature it is sufcient to press P1 and P2 keys according to the desired temperature

inside the menu “SET TEMP ROOM”.

• To see the set temperature, press once P1 key.

12.10 FUME TEMPERATURE

To check the fume temperature at the exhaust it is sufcient to keep pressed P2 key.

12.11 SWITCHING OFF

To switch the stove off, keep pressed P4 key: the display shows “FINAL CLEANING”. After about 10 minutes, also

the fume fan switches off (this happens always, independently if the stove is hot or cold). Then “OFF” will be

shown.

If the pellets are of bad quality (if contains sizing agents, oils, varnishes, plastic remains or if

it is mealy), deposits will form along pellets drop pipe during the running. When the stove is

switched off, these remains could form little hot coals that rising along the pipe could reach

the pellets on the hopper burning them and creating a thick and harmful smoke inside the

room. Please always keep the hopper closed with its own lid. If the pipe is sooty, please

clean it (see INTRODUCTION page 23).

12.12 CLOCK SETTING

• Press P3 key and then P5 key till underlining “SET CLOCK” menu (02).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadel Kriss Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadel Kriss

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info