Bedienungsanleitung Cadel Lean3 Plus (Seite 30 von 48) (Englisch)

694402

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

WALL

PLUS - LEAN

PLUS - MOON - TILE

PLUS

12.8 FAILED IGNITION

If pellets should not ignite, the lack of ignition will be signalled by the A01 "No Ignition" warning.

If the ambient temperature is below 5°C, the resistance may not heat up enough to guarantee the pallet ignition.

In this case, remove the unburned pellets from the burning pot and restart ignition.

• Too much pellets in the burning pot, or humid pellet, or sooty burning pot make ignition difcult and create

dense white smoke which is harmful to health and can cause explosions on the combustion chamber. It is

therefore necessary not to stand in front of the stove during ignition stage if dense white smoke is present.

If after some months the ame appears weak and/or orange colored or the glass tends

to blackens and the burning pot to become encrusted, clean the stove, clean the fume

conduit and the chimney ue.

12.9 SWITCH OFF (ON PANEL: OFF WITH FLASHING FLAME)

If the shutdown key is pressed or if there is an alarm signal, the boiler goes into the thermal shutdown phase which

entails the automatic execution of the following stages:

• Pellet loading is stopped.

• The room fan continues to operate until the requested temperature is reached.

• The ue fan is set to its highest value, which it keeps until the requested temperature is reached, plus a

safety time of 10 additional minutes. After that, if the fume temperature has decreased below the switch off

threshold, it stops, otherwise the cooling process goes on.

• If the stove has switched off normally, but owing to thermal inertia, the fume temperature goes over the

threshold again, the switch off process is reactivated until the temperature decreases again.

12.10 POWER FAILURE

• After a black-out lower than 10 seconds, the stove turns back to the power which was settled.

• After a black-out of more than 10 seconds, the stove enters the during shutdown. Completed this phase, it

starts automatically up with the different phases.

12.11 ADJUSTMENTS MENU

To access the adjustments menu act as follows:

• Press the + - keys

• Scroll with the <> arrows and select “Set Room T ” or “Air Fan Speed 1” or “Air Fan Speed 2” or “Comfort

Mode” or "Fire"

• Press “menu” to access the selected option.

• Modify with the + - keys.

• Press “menu” to conrm and “esc” to exit.

Set Room T. - this function allows setting the desired temperature in the room where the stove is installed, starting

from a minimum of 5°C up to a maximum of 35°C. When this condition is met, the stove reaches the minimum

consumption values (ame and hot air fan speed at minimum values) and then goes back to theset values when

the ambient temperature goes below the set threshold (see ).

Fig. 55 - Display

Note: The full stop to the right of the ambient temperature shown in the control panel display (upper right)

indicates the half degree (e.g. 23.° means 23.5°C).

Air Fan Speed 1 - this function allows selecting the desired speed for the ambient fans from 1 to 5 or A. A means

automatic, ventilation depends on power, recommended setting (see Fig. 56 page 31).

Air Fan Speed 2 - this function allows selecting the desired speed for the DUCTING fans from 1 to 5 or A. A means

automatic, ventilation depends on power, recommended setting (see Fig. 57 page 31).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadel Lean3 Plus Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadel Lean3 Plus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info