809119
18
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
15
ADDING START-UP CHEMICALS
WATER CHEMISTRY
GUIDELINES
Spa water chemistry is ultimately the responsibility
of the spa owner. Improper water chemistry may
result in costly repairs not covered under the spa
warranty. If unsure about any steps in the process
below, please contact your local Dealer.
Initially, it is advisable to identify what minerals
(e.g. iron) are present in the local source water.
This will provide a better understanding of how
to treat the water. Please follow the four steps
below and be sure to achieve the correct levels
in each area before moving onto the next step.
ADD all chemicals into filter compartment while
running jets for 10 minutes.
STEP #1: ESTABLISH PROPER PH
LEVEL:
The recommended range for pH is between
7.2 and 7.8. Above 7.8, the water is too
alkaline and can result in cloudy water, and
scale formation on the shell and heater. To
lower the pH use a pH Down/Decreaser
(sodium bisulfate). Below 7.0 (considered
neutral), the spa water is too acidic and can
damage the heating system. To increase pH,
use a pH Up/Increaser (sodium hydrogen
carbonate). Any pH Up or Down should
be added one teaspoon at a time, waiting
one-half hour between application and
re-measuring.
STEP #2: MEASURE TOTAL
ALKALINITY:
The Total Alkalinity is the amount of
bicarbonates, carbonates, and hydroxides
present in the spa water. Proper total
alkalinity is important for pH control. If the
TA is too high, the pH is difficult to adjust.
If the TA is too low, the pH will be difficult
to hold at the proper level. The ideal range
is between 40-120 parts per million (PPM).
Reduce TA by using an Alkalinity Down/
Decreaser (sodium bisulfate). Increased TA
by adding an Alkalinity Up/Increaser (sodium
bicarbonate or sodium hydrogen carbonate).
These products should be added in small
amounts – 5 ml at a time. After adding 5
ml, wait one half hour before re-measuring.
Once the safe range of total alkalinity is
established, proceed to the next step..
STEP #3: DETERMINE CALCIUM
HARDNESS:
It is important to bring the calcium reading to
between 75-150 PPM. If the reading requires
adjustment, it should now be corrected. If
the water is too soft (a low reading) calcium
hardness should be added to the water to
increase the PPM reading. If the water is too
hard (a high reading), it can be corrected by
either: (A) a mixture of hard and soft water
added to attain a reading in the safe range,
or (B) addition of stain and scale control. If
calcium hardness is a problem with the local
source water (either too hard or too soft) a
test kit, which measures calcium hardness, is
essential.
STEP #4: SANITIZING:
After steps 1-3 are complete, the spa must
be sanitized using Chlorine (sodium
dichlor). Add 2 teaspoons of Chlorine, and
increase as necessary to reach a level of
1-3 ppm. Check and maintain this level
weekly, and before and after using the spa.
IMPORTANT NOTE: A granulated sodium
dichlor is highly recommended for sanitizing
spa water, granular bromine may also be
used. Never use compressed sanitizers
even with a floater. As with any other
chemicals, the sanitizer should be introduced
to the spa with the jets running a minimum of
10 minutes.
WEEKLY SHOCK:
Using a potassium monopersulfate (MPS)
shock, add approximately 60 ml (2 oz) over
the filter while the jets are running. Shocking
is achieved by adding the MPS to turbulent
water. Leave the cover up and jets on high
for 10 minutes. Then shut jets off and return
the cover to the closed position to maintain
heat.
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Caldera Fantasy Spa 2020 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Caldera Fantasy Spa 2020

Caldera Fantasy Spa 2020 Bedienungsanleitung - Holländisch - 24 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info