640T V2.0 DAB/FM tuner
Azur DAB/FM tuner 11
OPERATING INSTRUCTIONS
Tuning and listening
1. Press the DAB/FM button to toggle between DAB and FM modes.
When in FM mode, ‘FM’ is shown in the top right hand corner of the
display.
2. In DAB mode, press the Skip/Scan buttons to scroll through the
receivable stations. Press the Select button to listen to your chosen
station.
3. In FM mode, press the Autotune button to scan up to the next
available station (dependant on signal strength). Press and hold
Autotune to scan down to the next available station. Use the
Skip/Scan buttons to manually tune in 0.05Mhz increments.
DAB manual tuning
1. In DAB mode, hold the Info button down until ‘Manual Tune’ appears
on the front panel display, then press Select and the frequency and
name of the particular station will be displayed.
2. Use the Skip/Scan buttons to adjust the transmission group.
3. After pressing Select again it is possible to select a station from the
chosen transmission group.
4. Press Select again to exit from manual tuning.
Setting presets
1. Select the station you wish to store and hold down the desired preset
number (e.g 3) until the display shows that the station has been
stored.
2. To store the presets 6-10 press the Shift button first. You can store
20 stations for both FM and DAB. Press and hold Shift to toggle
between the sets of 10 presets.
3. Press the chosen preset button at any time to listen to the
corresponding station.
Note: When a preset is stored, the current NCT mode is stored with it
(i.e. each preset can have its own NCT mode).
Setting the clock
The user can either allow RDS FM transmissions to automatically set the
clock time/date, or the clock can be set manually if you cannot receive
RDS FM transmissions. To change the clock modes:
1. Press and hold the Alarm/Clock button on the remote control until the
display reads ‘Clk Mode’.
2. Use the Skip/Scan buttons on the remote to scroll between RDS
“sync” mode and Manual mode.
3. Press the Alarm/Clock button to confirm your choice. Press again to
exit from setting the clock.
If manual mode is selected, you can set the time by first adjusting the
hour using the Skip/Scan buttons, then press Alarm/Clock again to
adjust the minutes. Press Alarm/Clock to finish.
