Bedienungsanleitung Cambridge Audio Stream Magic 6 V2 (Seite 4 von 20) (Englisch)

656763

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

– The unit will become hot when in use. Do not stack multiple units on top of each

other. Do not place in an enclosed area such as a bookcase or in a cabinet without

sufcient ventilation.

Ensure that small objects do not fall through any ventilation grille. If this happens,

switch off immediately, disconnect from the mains supply and contact your dealer

for advice.

Choose the installation location carefully. Avoid placing it in direct sunlight or close

to a source of heat. No naked ame sources, such as lighted candles, should be

placed on the unit. Also avoid locations subject to vibration and excessive dust,

cold or moisture. The unit can be used in a moderate climate.

This unit must be installed on a sturdy, level surface. Do not place in a sealed area

such as a bookcase or in a cabinet. Do not place the unit on an unstable surface or

shelf. The unit may fall, causing serious injury to a child or adult as well as serious

damage to the product. Do not place other equipment on top of the unit.

Due to stray magnetic elds, turntables or CRT TVs should not be located nearby

due to possible interference.

Electronic audio components have a running in period of around a week (if used

several hours per day). This will allow the new components to settle down and the

sonic properties will improve over this time.

the marking label. If you are not sure of the type of power-supply to your home,

consult your product dealer or local power company.

This unit can be left in Standby mode when not in use and will draw <0.5W in this

state. To turn the unit off, switch off at the rear panel. If you do not intend to use

this unit for a long period of time, unplug it from the mains socket.

Do not overload wall outlets or extension cords as this can result in a risk of re

or electric shock. Overloaded AC outlets, extension cords, frayed power cords,

damaged or cracked wire insulation and broken plugs are dangerous. They may

result in a shock or re hazard.

Be sure to insert each power cord securely. To prevent hum and noise, do not

bundle the interconnect leads with the power cord or speaker leads.

To clean the unit, wipe its case with a dry, lint-free cloth. Do not use any cleaning

uids containing alcohol, ammonia or abrasives. Do not spray an aerosol at or

near the unit.

Batteries may contain substances harmful to the environment. Please dispose

of any discharged batteries with due consideration and in accordance with local

environmental/electronic recycling guidelines.

Before making any connections to loudspeakers, make sure all power is turned off

and only use suitable interconnects.

These units are not user serviceable. Never attempt to repair, disassemble or

reconstruct the unit if there seems to be a problem. A serious electric shock could

result if this precautionary measure is ignored. In the event of a problem or failure,

please contact your dealer.

Wi-Fi information

FCC Statement

Caution: Exposure to Radio Frequency Radiation.

The device shall be used in such a manner that the potential for human contact

during normal operation is minimized.

When connecting an external antenna to the device, the antenna shall be placed

in such a manner to minimize the potential for human contact during normal

operation. This transmitter must not be co-located or operating in conjunction with

any other antenna or transmitter.

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation.

This equipment generates, uses, and can radiate radio frequency energy, and if

not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try and correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the distance between the equipment and the receiver.

• Connect the equipment to an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modications not expressly approved by the

party responsible for compliance could void the user’s authority to operate this

equipment.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with a

minimum distance of 20cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

2 .4GHz operation of this product in the USA is rmware-limited to channels 1

through 11.

Modications

The FCC requires the user to be notied that any changes or modications to this

device that are not expressly approved by Cambridge Audio, may void the user’s

authority to operate the equipment.

Canada-Industry Canada (IC)

This Class B digital apparatus complies with Canadian ICES-003

This device complies with Industry Canada licence-exempt RSS standard(s).

Operation is subject to the following two conditions: (1) this device may not

cause interference, and (2) this device must accept any interference, including

interference that may cause undesired operation of the device.

Under Industry Canada regulations, this radio transmitter may only operate using

an antenna of a type and maximum (or lesser) gain approved for the transmitter by

Industry Canada. To reduce potential radio interference to other users, the antenna

type and its gain should be so chosen that the equivalent isotropically radiated

power (e.i.r.p.) is not more than that necessary for successful communication.

This radio transmitter 9095A-651N01 has been approved by Industry Canada to

operate with the antenna types listed below with the maximum permissible gain

and required antenna impedance for each antenna type indicated. Antenna types

not included in this list, having a gain greater than the maximum gain indicated for

that type, are strictly prohibited for use with this device.

C059-510137-A; Antenna+RG-178 Cable+SMA Plug Reverse, 3.0dBi, 50Ω

This equipment complies with RSS-102 limits set forth for an uncontrolled

environment. This equipment should be installed and operated with a minimum

distance of 20cm between the radiator and your body.

DECLARATION OF CONFORMITY WITH FCC RULES FOR ELECTROMAGNETIC

COMPATIBILITY

We, Cambridge Audio, of Gallery Court, Hankey Place, London SE1 4BB,

declare under our sole responsibility that this device,

Stream Magic 6 with Wi-Fi module

to which this declaration relates, complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Cambridge Audio Stream Magic 6 V2 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cambridge Audio Stream Magic 6 V2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info