Bedienungsanleitung Campingaz DELANO CLASSIC (Seite 10 von 103) (Alle Sprachen)

662257

Zoom out

Zoom in

Vorherige Seite

1/103

Nächste Seite

2) To use the equipment with the flexible hose XP D

36-112, G 1/2 and M 20x1.5 nuts: (solution d) b))

- loosen and remove the NF ringed tailpiece to release

the G 1/2 inlet connector.

- remove the seal

- tighten the G 1/2 threaded nut on the hose onto the

barbecue inlet connector and the M20x1.5 threaded nut

onto the regulator output connector following the

instructions supplied with the flexible hose.

- use a spanner to tighten or loosen the threaded nut.

- use a spanner to hold the regulator outlet connector

firm.

- check for leaks following the instructions in paragraph f).

Check that the flexible hose stretches out normally

without twisting or pulling and does not come into contact

with the hot sides of the barbecue. It should be replaced

when the expiry date on the hose is reached or whenever

it is damaged or develops surface cracks.

n Belgium, Luxembourg, Great Britain, Ireland,

Portugal, Spain, Italy, Croatia, Greece, Netherlands,

Czech Republic, Slovakia, Hungary, Slovenia,

Norway, Sweden, Denmark, Finland, Bulgaria,

Romania, Poland:

The barbecue is equipped with a circular connector. It

should be used with flexible hose that is suitable for use

with butane and propane gas. Hose length should not

exceed 1.20 metre. It should be replaced if it is damaged

or cracked, when required by national regulations or at the

end of the part lifecycle. Do not pull or pierce the hose.

Keep away from any parts of the barbecue that get hot.

Check that the flexible hose stretches out normally,

without twisting or pulling.

n Switzerland:

The barbecue must be used with flexible hose that is

suitable for use with butane and propane gas. Hose length

should not exceed 1.50 metre. It should be replaced if it is

damaged or cracked, when required by national

regulations or at the end of the part lifecycle. Do not pull

or pierce the tubing. Keep away from any parts of the

barbecue that get hot. Check that the flexible hose

stretches out normally, without twisting or pulling.

Flexible hose connection: to connect the hose to the

connector on the barbecue, tighten the nut on the hose

firmly but without excess force using the two wrenches

provided:

- no. 14 wrench to tighten the connector

- no. 17 wrench to tighten the nut on the hose

e) LID

Handle the lid carefully, especially during operation. Do

not lean over the firebox.

f) CHECKING FOR GAS LEAKS

1) Work outside, away from all sources of ignition. Do not

smoke.

2) Make sure the control knobs are in the "off" (l)

position.

3) Connect the flexible hose to the connector and

barbecue as described in part d).

4) Fit the regulator onto the gas cylinder in accordance

with its instructions.

5) Use a gas leak solution to test for leaks. Important:

never use a naked flame to check for gas leaks.

6) Apply the solution to the connections cylinder/regulator/

hose/apparatus (the control knobs should remain

closed: off position (

l)). Open the gas cylinder valve.

7) Bubbles in the gas leak solution indicate that there are

gas leaks.

8) The leak can be stopped by tightening any hose

connection or replacing any faulty component. The

barbecue must not be used until the leak has been

repaired.

9) Close the valve on the gas cylinder.

Important:

Check for leaks at least once per year and each time the

gas cylinder is replaced.

g) PRIOR TO USE

Never use the barbecue until the instructions have been

read carefully and understood. Also, be certain that:

- there are no leaks

- the venturi tubes are not blocked (example: spider

webs)

- the hose does not touch any components which may get hot.

- that the ventilation openings in the gas receptacle

housing are not obstructed, if appropriate.

h) LIGHTING THE BARBECUE BURNERS

Read steps 1 to 7 before beginning with step 1.

1) Open the lid.

2) Make sure that the control knobs are in the "OFF"

position (l).

3) Push the end of the hose completely onto the regulator

nozzle and secure with a suitable clip. Fit the regulator

onto the gas cylinder in accordance with its

instructions.

4) Open the gas cylinder valve.

5) Press one of the 2 control knobs and turn it to the

FULL FLAME ( ) position. Wait about 5 seconds, then

press the igniter button ( ) until you hear the click.

Repeat 3 or 4 times if necessary until the burner is lit.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Campingaz DELANO CLASSIC Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info