Bedienungsanleitung Campingaz Shashlik Rotario (Seite 13 von 56) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

662455

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

- 13 -

Consumption: 182 g/h (2.5 kW) - injector n° 48

Category: butane direct pressure

Thank you for choosing this Campingaz

Shashlik

Rotario camping stove.

Figures: see pages 2 to 8.

A - IMPORTANT: YOU ARE USING GAS, BE

VERY CAREFUL!

The purpose of these instructions is to enable you

to use your Campingaz

appliance correctly and in

complete safety.

Please read them carefully to familiarise yourself

with the equipment prior to assembling the gas

container. Keep these instructions in a safe place so

that you can refer to them if needed.

Please observe these instructions and the safety

measures printed on the Campingaz

CV 470 PLUS

cartridges. Failure to observe these instructions

may result in the user and people in the immediate

vicinity being put at risk.

This equipment must be used exclusively with

Campingaz

CV 470 PLUS cartridges. Using other

gas containers may be dangerous.

The Société Application Des Gaz accepts no

responsibility where cartridges of any other make

are used.

This equipment should only be used outside

premises and kept away from inflammable materials.

Do not use equipment which leaks, functions

incorrectly or is damaged. Return it to your retailer

who will inform you of your nearest after-sales

service.

WARNING: accessible parts may be very hot. Keep

young children away from the device.

Never modify this equipment or use it for purposes

for which it is not intended.

Do not use this product in caravans, cars, tents,

huts, sheds or any small enclosed areas.

The product should not be used while sleeping or

left unattended.

This product consumes fuel through combustion or

consumption of oxygen and gives off certain

substances and gas, which could be dangerous

such as carbon monoxide.

Carbon monoxide is an odorless, clear gas that can

cause flu-like symptoms, sickness, illness, and

possibly death if produced inside aforesaid

enclosed areas through use of the product without

proper ventilation.

B – PREPARING THE DEVICE

- Open and unfold the two feet (1) (fig. 1) and the hook

(16) located on top of the device.

- Lie the device in a horizontal position and fully raise

the two hooks (2) located at the rear of the device to a

vertical position (fig. 2).

- Carefully open the device until you hear a click (fig. 3),

then push the two locking hooks (2) down.

- Take the drippings tray (3) and the five spits (4) out of

the device (fig. 4).

- Remove the spring (5) that keeps the spit holder in

place (6) by unfastening the hooks located on each

end of the spring (fig. 5). Put the spring in a place

where it will be easy to find.

- Remove the spit holder frame (6) from the burner cage

(7) by pulling it out (fig. 6).

- Place the spit holder frame (6) inside the burner cage

(7) by aligning the “C” hooks and the lower “B” stops

with the tabs located on each side of the burner cage

(fig. 7). Ensure that the frame is snugly attached to the

burner cage.

- Remove the spit motor (8) positioned behind the

device by detaching the adhesive band (fig. 8).

- Inserting a battery in the spit motor: The motor

operates on a Type D (LR20) 1.5 V battery. Unscrew

the battery housing in the direction indicated in figure 9

after carefully removing the protective plastic sleeve.

- Place the battery inside the housing in the direction

indicated in figure 9, then reposition the housing by

aligning the slots in the housing with the tabs on the

motor following the “A” axis – see figure 9.

- Put the protective plastic sleeve back in place on the

motor to ensure that the motor is watertight in case of

rain or the presence of moisture.

- Check that the motor is working by activating the red

motor button (two rotational directions).

- Put the spit motor (8) in place as indicated in figure 9.

Be sure that the motor hole coincides with the

corresponding hole in the spit holder frame.

- Inserting spits (4) on the spit holder frame (6) (fig.

10): The spits must be inserted starting at the bottom

(spit motor). Hold a spit by placing your middle and

index fingers in the “a” area, then push on the “b”

handle with your thumb (fig. 10). Keep pushing as you

thread the spit in the hole located on the motor side,

then place it in the slot located on the other side. Stop

pushing on the “b” handle. The toothed wheel should

be on the outside of the frame.

Inserting the lower spit: To insert the spit in the motor

hole (8) (fig. 10), raise the motor slightly and insert the

spit in the hole.

- When all the spits are in place, turn on the motor (8) to

check that the spits turn properly (fig. 11). The five

spits should turn together.

- Insert the drippings tray (3) (fig. 11).

- Remove the regulator (9) from its housing by pulling

firmly (fig. 12) and insert a Campingaz

CV 470 Plus

gas cylinder (see the paragraph below on INSERTING

A CAMPINGAZ

CV 470 PLUS CYLINDER).

- When the gas cylinder has been connected to the

regulator, hang the regulator-cylinder unit on the

device as shown in figure 14.

INSTALLING THE CAMPINGAZ

CV 470 PLUS

CARTRIDGE

Where the existing cartridge is empty, read paragraph D:

"Changing the cartridge").

When installing or changing a cartridge, always operate

in a very well-ventilated location, preferably outside,

never near a flame, heat source or spark (cigarette,

electric apparatus, etc.) and far away from other people

and inflammable materials.

Campingaz Shashlik Rotario Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info