5. Check if the voltage listed on the product ratting label corresponds to the voltage of the power network in your home
yourself.
Before using the device, the feet (supplied separately in the carton), must be fitted to the device. These are to the base of the heater using
the 10 self-tapping screws provided. Take your care to ensure that they are located correctly in the bottom ends of the device side
moldings. Do not use the device when glass surface is damaged. The device is not intended to be hanged on the wall.
2. During installation, in no case may the device be covered with insulating material or similar material
3. When assembling the device, beams and rafters should not be cut or cut
6. Do not use the device unless the feet are correctly attached
17. Always unplug the device when moving it from one location to another .
7. Keep the mains lead away from the hot body of the device.
15. Do not insert any object through the heater outlet or air intake grills of the device.
16. Do not use the device in areas where flammable liquids are stored or where flammable fumes may be present.
INSTALLATION IN STANDING POSITION ON THE FLOOR
8. The device is not intended for use in bathrooms, laundry areas or similar indoor locations. Never place the device where it may fall into a
bathtub or other water container.
10. Do not place any objects close to the outlet grills or the air intake openings of the device when operating.
Product description: LCD CONVECTOR HEATER with remote control
I. LCD display II. Control panel III. Glass panel
9. Do not use accessories that are not recommended by the manufacturer. They may pose a
danger to the user and may cause damage to the device.
9. Do not use outdoors.
12. CAUTION: Some parts of this device may become very hot during operation and cause
burns.
III. BEFORE FIRST USE
11. Do not place the device on carpets having a very high hairs.
8. Never wash the device under running water or in such a way that water drips into it.
11. Do not touch the housing during use. During operation, use only knobs and switches.
After switching off, wait for the device to cool down.
12. Always ensure that the device is placed on a firm level surface. Ensure that the device is not positioned close to curtains or furniture as
this could create a fire hazard.
13. Do not position the device in front of, or immediately below, a wall socket.
14. Do not position the under the window.
1. Remove all packing material and straighten the power cord
10. Ensure that the device has cooled down before storing.
4. Before first use read all instructions for use.
7. Up button 8. Down button
1. Insert the mains plug into a wall socket corresponding to the technical data.
IV. Power switch V. Remote control
9. Maximum heating power indicator 10. Minimum heating power indicator
USAGE
13. Timer indicator (time remaining until automatic shutdown)
Control panel description
1. Temperature unit indicator C° 2. Timer activation indicator
3. When you press the power button (3), the minimum heating settings (10) will appear on the readout. The default setting is 35°C, so if the
room temperature drops below the value, the heating system start up.
2. Push the power switch (IV.) on the right side of device, the control panel (II.) will light up, showing a readout of the room temperature
indicate (12) in Centigrade (°C) and timer indicator (13). The timer indicator (13) will be set to zero.
11. Heating activation indicator 12. Room temperature indicator
4. Press the TEMP button (5) once and readout indicating the heating temperature will flash. At his point, use the button (7) and (8) to set
The remote control (V.) operation way is same as buttons on control panel (II).
3. Power button 4. PROG – heat level button
5. TEMP – set temperature button 6. TIME – timer button
7
