Bedienungsanleitung Canadian Spa Company Toronto SE (Seite 6 von 24) (Englisch)

764895

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

TORONTO SE

Choose your location

The hot tub location is very important to optimise your bathing

experience and provide a relaxing environment for you and

your family. Therefore, the following points should be

considered:

• The view from the house to the spa, and the view from the

Spa in the garden.

• Direction of neighbours, doors, fences or trees.

• Ensure quick and easy access from your house to the spa.

• Direction of drainage. Water should always drain away from

the spa. Do not locate your spa in a low run-off area – rain

water could ood the area and cause pump and equipment

damage.

• If you are installing the spa within a deck, the entire spa

base must be sitting directly on the prepared base. The lip

of the shell must not support any weight.

• The minimum clearance for entry to the spa’s access panel

for servicing is 0.75m.

• The spa should not be located near or under overhead

wires and must be kept clear of all electrical appliances

• A sheltered environment can result in lower operating and

maintenance costs.

Planning Permission

Under normal circumstances planning permission is not

required, but we recommend consulting your local planning

ofce prior to purchase.

Local Regulations

There may be certain restrictions and/or requirements that

are particular to your locality. If in doubt, check with your local

council.

Installation and Ground surface requirements

• Ground preparation is not included in the sale of any spa or

gazebo. The location where you are planning to put your

spa and/or gazebo must be completely prepared.

• The site must be smooth, at and level, to ensure complete

contact with the bottom of your spa.

• Hot Tubs and Swim-Spas are extremely heavy; therefore, a

solid support is essential.

A 10-15cm thick reinforced concrete slab is ideal, in most

cases your spa can be placed on a properly tted existing

patio. Your spa can be mounted on a deck, but it must be of

solid construction capable of holding the weight of your spa

and water. Either way, it is recommended you install your spa

at ground level to allow easy internal access.

• The base needs to be at least the same size as the footprint

of your spa

• You must allow 0.75 metre clearance for access to the

spa’s access panel for servicing.

• You will need to get a qualied electrician to undertake this

work

• Plug and play models plug directly into a 13Amp socket.

Pre-Delivery Information

Before delivery check your spa

height and width and add 5cm

clearance on each side to ensure

access.

Check that the hot tub can

clear a 90° turn

Rotary Isolation Switch

(pictured). Make sure you have

a qualied electrican prepare

the electrics. Allow 5 metre

slack to connect to Spa.

Ensure you have prepared

a level concrete base or a

properly tted existing patio or

decking with access to a drain.

Delivering your Canadian Spa

(6)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Canadian Spa Company Toronto SE Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info