Bedienungsanleitung Canadian Spa Company Toronto SE (Seite 9 von 24) (Englisch)

764895

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

TORONTO SE

Spa operation - Starting your hot tub/spa

POWERING UP YOUR SPA

Once the spa is properly wired and lled with water, the spa power can

be turned on and Start-up chemicals added.

1. Turn on RCD breaker. If breaker trips immediately check

Neutral and Ground Wire connections. Upon initial power up,

4 sets of numbers ash on the LED display of the topside

Console. The last number in the sequence is the incoming

power meter which can be used to verify that the spa is wired

correctly.

2. The spa begins an automatic priming routine which will last 6

minutes (“Pr” is on the LED display).

3. The priming routine will automatically run each spa pump to

prime. When the “Pr” is displayed, press any PUMP button

to prime that pump or wait for the priming routine to turn

on the Pump. IMPORTANT: To avoid pump damage, do not run

pumps for more than 1 minute without moving water. If no water

is moving, turn the power off and perform air lock procedure.

4. The Topside Console display ashes “38C/100F” then press

“--C/F” for approximately 2 minutes to determine water

temperature as it ows through the heater.

5. The default pre-set temperature is 36.5°C. The last measured

temperature is constantly displayed on the LCD readout. This

temperature will be current only when the pump has been

running for at least 2 minutes. Set the desired temperature

between 26- 40°C (80-104°F) by pressing the temp button(s).

If the water temperature is below the set temperature, the spa’s

heater and heat indicator light will turn on. All features of

the Topside Console will be available. The spa will heat

approximately 1° every 30 minutes per 1,000 litres.

6. Check for leaks! Although spas are fully checked at the factory,

shipping & delivery might cause a leak. Remember to pay

particular attention to barrel unions adjoining the heater.

Contact your Canadian Spa dealer directly if there is a problem.

If your new spa pump does not prime (ow) on the initial start-up you

may be experiencing an “air lock”.

This normal occurrence can be easily corrected by loosening the

plumbing union on the suction side of the Jet or Pump until water

ows into the pump and all air is expelled.

PRESS BUTTONS SLOWLY FOR FIRST RUN WHEN STARTING UP

ONCE PR EXITS, SET TEMPERATURE ON SPA (SEE SPA OPERATION

SECTION FOR DIFFERENT SPA TOPSIDES)

How your spa functions

BASIC: Water is drawn through the drains in the foot well and the

skim lter on the side of the spa. Water is pumped through a lter,

over the heater, into the Ozone Reaction Chamber and returns to the

jets. Water entering the spa has been ltered, heated and mixed with

air ready for use. Note: A sensor on the heater ensures water ow

over the heater before allowing the heater to energise.

JETS: All regular jets can be ow adjusted by rotating the face of the

jet. As the jet is turned clockwise the air at the jet is gradually re-

duced, then the water. As the jet is rotated counter-clockwise, water

ow is increased then the water and air mix is increased.

FILTER: A weir is located on the skimmer. It is used to skim oils and

oating pieces of debris from the surface of the spa. (If applicable,

the weir should be facing into the skimmer opening).

AIR CONTROLS: Air Controls inject air into the jets via a venturi

system. Rotating the left or right control from Min. to Max. activates

the air control.

NOTE: The system functions when your jets are at full power only.

Spa operation - Filtration cycle

(9)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Canadian Spa Company Toronto SE Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info