Bedienungsanleitung Casio 3269 - GR-8900 (Seite 4 von 6) (Englisch)

624516

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Operation Guide 3269

E-30

Illumination

This watch has an EL (electro-luminescent) panel that

causes the entire display to glow for easy reading in the

dark. The watch’s auto light switch turns on illumination

automatically when you angle the watch toward your face.

• The auto light switch must be turned on (indicated by

the auto light switch on indicator) for it to operate.

• See “Illumination Precautions” (page E-49) for other

important information about using illumination.

To illuminate the display manually

In any mode, press L to turn on illumination.

• The above operation turns on illumination regardless of

the current auto light switch setting.

• You can use the procedure below to select either 1.5

seconds or 3 seconds as the illumination duration. When

you press L, the illumination will remain on for about

1.5 seconds or 3 seconds, depending on the current

illumination duration setting.

Auto light switch

on indicator

E-31

To specify the illumination duration

1. In the Timekeeping Mode, hold down A until the

display contents start to flash. This is the setting screen.

2. Press C 10 times to display the current illumination

duration (LT1 or LT3).

3. Press D to toggle the setting between LT1 (1.5

seconds) and LT3 (three seconds).

4. Press A to exit the setting screen.

E-32

About the Auto Light Switch

Turning on the auto light switch causes illumination to turn on, whenever you position

your wrist as described below in any mode.

Moving the watch to a position that is parallel to the ground and then tilting it toward

you more than 40 degrees causes illumination to turn on.

• Wear the watch on the outside of your wrist.

Parallel to

ground

More than

40°

E-33

• Illumination may not turn on if the face of the watch is

more than 15 degrees above or below parallel. Make

sure that the back of your hand is parallel to the ground.

Warning!

••

• Always make sure you are in a safe place whenever you are reading the

display of the watch using the auto light switch. Be especially careful when

running or engaged in any other activity that can result in accident or injury.

Also take care that sudden illumination by the auto light switch does not

startle or distract others around you.

••

• When you are wearing the watch, make sure that its auto light switch is turned

off before riding a bicycle or operating a motorcycle or any other motor

vehicle. Sudden and unintended operation of the auto light switch can create a

distraction, which can result in a traffic accident and serious personal injury.

Lower than 15 degrees to

illuminate

E-34

To turn the auto light switch on and off

In the Timekeeping Mode, hold down L for about three seconds to toggle auto light

switch on (indicator

is shown on the display) and off.

• The auto light switch on indicator (

) is shown on the display in all modes while

the auto light switch is turned on.

E-35

Power Supply

This watch is equipped with a solar cell and a rechargeable battery that is charged by

the electrical power produced by the solar cell. The illustration shown below shows

how you should position the watch for charging.

Example: Orient the watch so its face is

pointing at a light source.

• The illustration shows how to position a

watch with a resin band.

• Note that charging efficiency drops when

any part of the solar cell is blocked by

clothing, etc.

• You should try to keep the watch outside

of your sleeve as much as possible.

Charging is reduced significantly if the

face is covered only partially.

Solar cell

E-36

Important!

• Storing the watch for long periods in an area where there is no light or wearing it in

such a way that it is blocked from exposure to light can cause rechargeable battery

power to run down. Be sure that the watch is exposed to bright light whenever

possible.

• This watch uses a rechargeable battery to store power produced by the solar cell, so

regular battery replacement is not required. However, after very long use, the

rechargeable battery may lose its ability to achieve a full charge. If you experience

problems getting the rechargeable battery to charge fully, contact your dealer or

CASIO distributor about having it replaced.

• Never try to remove or replace the watch’s rechargeable battery yourself. Use of the

wrong type of battery can damage the watch.

• The current time and all other settings return to their initial factory defaults whenever

battery power drops to Level 5 (pages E-37 and E-38) and when you have the

battery replaced.

• Turn on the watch’s Power Saving function (page E-45) and keep it in an area

normally exposed to bright light when storing it for long periods. This helps to keep

the rechargeable battery from going dead.

E-37

Battery Power Indicator

(Charge Soon Alert)

Battery Power Indicator and Recover Indicator

The battery power indicator on the display shows you the current status of the

rechargeable battery’s power.

Level

Function Status

All functions enabled.

Illumination, and beeper

disabled.

Except for the CHG (charge)

indicator, all functions and

display indicators disabled.

All functions disabled.

Battery power

indicator

E-38

• The flashing LOW indicator at Level 3 tells you that battery power is very low, and

that exposure to bright light for charging is required as soon as possible.

• At Level 5, all functions are disabled and settings return to their initial factory

defaults. Once the battery reaches Level 2 after falling to Level 5, reconfigure the

current time, date and other settings.

• The watch’s Home City code setting will change automatically to TYO (Tokyo)

whenever the battery drops to Level 5 or when you have the rechargeable battery

replaced.

• Display indicators reappear as soon as the battery is charged from Level 5 to

Level 2.

• Leaving the watch exposed to direct sunlight or some other very strong light source

can cause the battery power indicator to show a reading temporarily higher than the

actual battery level. The correct battery level should be indicated after a few minutes.

E-39

• Performing illumination or beeper operations during a

short period may cause

(recover) to appear on

the display. Illumination, alarm, countdown timer alarm

and hourly time signal will be disabled until battery

power recovers.

After some time, battery power will recover and

(recover) will disappear, indicating that the above

functions are enabled again.

• If

(recover) appears frequently, it probably means

that remaining battery power is low. Leave the watch in

bright light to allow it to charge.

Recover indicator

Casio 3269 - GR-8900 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Casio 3269 - GR-8900

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info