Bedienungsanleitung Casio 5311 - GW-A1100 (Seite 2 von 11) (Englisch)

624480

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

Operation Guide 5311

E-19

Power Saving

Power Saving enters a sleep state (second hand sleep or function sleep) whenever

the watch is left for a certain period in an area where it is dark.

Elapsed Time in Dark Operation

60 to 70 minutes (second

hand sleep)

Second Hand only stopped at 12 o’clock, all other functions

enabled

6 or 7 days (function sleep)

x All functions, including analog timekeeping, disabled

x Internal timekeeping maintained

x The watch will not enter a sleep state between 6:00 AM and 9:59 PM. If the watch is

already in a sleep state when 6:00 AM arrives, however, it will remain there.

x The watch will not enter a sleep state while it is in the Stopwatch Mode or

Countdown Timer Mode.

To recover from the sleep state

Move the watch to a well-lit area or press any button.

E-18

Charging Times

Exposure Level (Brightness)

Daily

Operation *1

Level Change *2

Level 3 Level 2 Level 1

Outdoor sunlight (50,000 lux) 8 minutes 2 hours 27 hours

Window sunlight (10,000 lux) 30 minutes 6 hours 99 hours

Window sunlight on cloudy day

(5,000 lux)

48 minutes 10 hours 161 hours

Indoor ﬂ uorescent lighting

(500 lux)

8 hours 111 hours – – –

* 1 Approximate exposure each day to generate power for normal daily operation.

* 2 Approximate exposure to take power up one level.

x The above times are for reference only. Actual times depend on lighting conditions.

x For details about the operating time and daily operating conditions, see the “Power

Supply” section of the Speciﬁ cations (page E-97).

E-17

x When power drops to Level 3, all settings (including timekeeping) will be cleared.

Recharging the battery will reset all settings to their initial factory defaults.

x When the watch is at Level 3, exposing it to light for a while will cause the

Second

Hand to move to the position of second 57. This indicates that charging has started.

Power Recovery Mode

The watch is designed to go into a power recovery mode that stops hand operation

temporarily whenever power suddenly drops below a certain level due to continuous

signal reception or other operations over a short period. Note that all operations are

disabled while the watch is in the power recovery mode.

The hands will move to the correct positions and the watch will resume normal

operation after power recovers (in about 15 minutes). Putting the watch in a location

where it is exposed to light will help power to recover sooner.

E-16

Low Power

Low power conditions are indicated by the movement of

the

Second Hand in the Timekeeping Mode.

x If the

Second Hand is moving normally at one-second

intervals, power is at Level 1.

x If the

Second Hand is moving at two-second intervals,

power is at Level 2, which is quite low. Expose the watch

to light as soon as possible so it can charge.

Low Battery Alert (Hand Movement and Function

Status)

Level Hand Movement Function Status

1 Normal. All functions enabled

Second Hand moves at

two-second intervals.

Beeper and time

calibration signal

reception disabled.

Second Hand stopped.

All functions disabled

Moves at two-second

intervals.



E-15

Warning!

Leaving the watch in bright light for charging can cause it to become quite hot.

Take care when handling the watch to avoid burn injury. The watch can become

particularly hot when exposed to the following conditions for long periods.

x On the dashboard of a car parked in direct sunlight

x Too close to an incandescent lamp

x Under direct sunlight

Important!

x Keep the watch in an area normally exposed to bright light when storing it for long

periods. This helps to ensure that power does not run down.

x Storing the watch for long periods in an area where there is no light or wearing it in

such a way that it is blocked from exposure to light can cause power to run down.

Make sure that the watch is exposed to bright light whenever possible.

Checking the Current Power Level

Certain functions will be disabled when the power level is low. If the power level is

low, leave the watch in a location where its face (solar panel) is exposed to light.

E-14

Charging the Watch

The face of the watch is a solar panel that generates power from light. The generated

power charges a built-in rechargeable battery, which powers watch operations. The

watch charges whenever it is exposed to light.

Charging Guide

Whenever you are not

wearing the watch, be sure

to leave it in a location

where it is exposed to light.

x Best charging

performance is achieved

by exposing the watch to

light that is as strong as

possible.

When wearing the watch,

makes sure that its face is

not blocked from light by

the sleeve of your clothing.

x The watch may enter a

sleep state (page E-19) if its

face is blocked by your

sleeve even only partially.

E-13

E-79 Adjusting Home Positions

E-81 To adjust home positions

E-83 Troubleshooting

E-95 Speciﬁ cations

E-12

E-63 Checking the Current Time in a Different Time Zone

E-64 To view the time in another time zone

E-67 To swap your Home City and World Time City

E-69 Using the Stopwatch

E-70 To enter and exit the Stopwatch Mode

E-70 To perform an elapsed time operation

E-70 To perform ﬂ yback timing

E-72 Using the Countdown Timer

E-73 To specify the countdown start time

E-74 To perform a countdown timer operation

E-74 To stop the alarm

E-75 Using the Alarm

E-76 To change the alarm time setting

E-78 To turn the alarm on or off

E-78 To stop the alarm

E-11

E-32 Mode Reference Guide

E-33 To determine the watch’s current mode

E-33 To return to the Timekeeping Mode from any other mode

E-34 To select a mode

E-35 Timekeeping

E-36 Conﬁ guring Home City Settings

E-36 To conﬁ gure Home City settings

E-39 To switch between standard time and summer time manually

E-41 Conﬁ guring Current Time and Day Settings Manually

E-41 To change the current time setting manually

E-44 To change the current day setting manually

E-48 Taking Direction Readings

E-50 To take a direction reading

E-56 To perform bidirectional calibration

E-58 To perform northerly calibration

E-10

Contents

E-3 About This Manual

E-4 Using the Crown

E-4 To lock the crown

E-5 To unlock the crown

E-5 To pull out, rotate, or push the crown in

E-8 Things to check before using the watch

E-14 Charging the Watch

E-19 To recover from the sleep state

E-20 Radio Controlled Atomic Timekeeping

E-25 To get ready for a receive operation

E-28 To perform manual receive

E-29 To check the result of the latest receive operation

E-30 To turn auto receive on and off

Casio 5311 - GW-A1100 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Casio 5311 - GW-A1100

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info