Disable Direct Disarm by RFID Tag
Enter setup state, input:
*7 * 0*
When one beep is heard and the LED indicator keeps on for 10
seconds, the setup is successful.
Enable Direct Disarm by RFID Tag
Enter setup state, input:
*7 * 1*
When one beep is heard and the LED indicator keeps on for 10
seconds, the setup is successful.
Note: Default setting: 0, disable the function of direct disarm by RFID tag.
Change User Code
Using user code can wake up keypad, open electronic door lock, or
send Arm, Disarm, Stay Mode commands to the control panel.
To avoid passcode reveal, please change user code when first time
use.
Change User Code
Enter setup state, input:
*8*new admin code*
When one beep is heard and the LED indicator keeps on for 10
seconds, the setup is successful.
Note: User code is 4 digits; default code is “1234”.
Change Admin Code
Using admin code can wake up keypad, send Arm, Disarm, Stay
Mode commands to the control panel, and also change any settings
of the keypad.
To avoid passcode reveal, please change admin code for first time.
Change Admin Code
Enter setup state, input:
*9*new admin code*
When one beep is heard and the LED indicator keeps on for 10
seconds, the setup is successful.
Note: Admin code is 6 digits; default code is “123456”.
Reset
After reset, the user code, admin code, and other settings will
restore to default except that the connected RFID tags can still
disarm and open electronic door lock.
Enter setup state, input:
*0 * *
When one beep is heard and the LED indicator keeps on for 10
seconds, the setup is successful.
Usage
Working with an alarm control panel, the keypad is more secure
than remote control, because user code or admin code should be
input before the operation of Arm, Disarm, Stay Mode, and Mute
Mode.
Arm
Input user code or admin code, and press [Arm] key, the LED
indicator flashes once and the keypad beeps once and sends [Arm]
command to the control panel.
When the alarm panel receives the signal, the siren will beep once
and the [Arm] indicator will light on. The alarm system enters armed
state.
If there is an intrusion, the alarm system will be triggered, the
siren will hoot and the control panel will send SMS and auto dial
to pre-stored phone numbers to notify users. (SMS notification is
applicable only for GSM alarm systems.)
Disarm
Users can disarm alarm system by using keypad or by using RFID
tags.
Using Keypad to Disarm
Input user code or admin code, and press [Disarm] key, the LED
indicator flashes once and the keypad beeps once and sends
[Disarm] command to the control panel.
When the alarm panel receives the signal, the siren will beep twice
and the Disarm indicator will light on, the alarm system enters
disarmed state. In this state, the sensors being triggered will not
cause an alarm.
Using RFID Tag to Disarm
If direct disarm by RFID tag is disabled, user needs to press [*] to
wake up the keypad and then put RFID tag close to the reader to
disarm and unlock the door.
If direct disarm by RFID tag is enable, user can put RFID tag close to
the reader to disarm and unlock the door directly.
