Bedienungsanleitung Charlton Jenrick Fireline Woodtec 5 (Seite 16 von 28) (Englisch)

707656

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

15 Woodtec Freestanding Issue 01.1 05/17

7.4 Air Controls

Keep air controls and inlets/outlets clean and free from ash or debris at all times. Keep direct

outside air inlet grille (if fitted) clean and clear at all times.

Do not leave air control fully open unless monitoring the fire as over firing damage can result

which is not covered by any warranty.

7.4.1 Single Air Control Operation

Secondary (air wash) and tertiary air is automatically controlled by the single control lever at the

bottom, underneath the stove door. The stove does not require Primary air as it only burns

wood. The fully IN position is the OFF position and closes off combustion air to the firebox. The

off position should only be used if absolutely necessary for very slow burning and will cause the

glass to become blackened, the chimney to gradually become tarred and smoke to be emitted

from the stove.

Wood burning: Pull the air control lever fully OUT for maximum air to start or revive a wood

fire. Returning the lever towards the centre position will reduce the air supply progressively to

reduce the burn rate. The nominal burn rate is usually achieved when the stove is fully warmed

up (2-3 loads of logs) and burning 2 dry hardwood logs by having the lever very approximately

30-35mm pushed IN from the fully out (maximum) position. This is only a rough guide as flue

and fuel conditions will vary the required position. The fire will automatically be supplied with

the correct mix of secondary and tertiary air for complete combustion. The maximum position

conveniently provides a boost of primary air as well to get new fuel burning quickly in order to

minimise smoke. Do not leave on maximum setting unless monitoring the fire to ensure over

firing damage does not occur.

7.4.2 Air Wash

All Fireline stoves are provided with a sophisticated “air wash” system to assist in keeping the

fire as visible as possible and reducing cleaning intervals. This secondary air supply to the stove

is controlled through the main single air control. The Clean Air Act air restrictor will deliberately

prevent full closure of this control on the Wood side of operation.

The glass will not remain fully clear indefinitely, entirely depending on fuel, flue and operational

settings, and will require cleaning with stove glass cleaner or ceramic hob cleaner from time to

time.

7.4.3 Tertiary Air

This appliance is also fitted with a patented tertiary air combustion system that burns otherwise

uncombusted gasses in the products of combustion thereby improving efficiency, increasing

heat output and decreasing unwanted atmospheric emissions. The Tertiary air supply to the

stove is controlled automatically by the draught in the flue and firebox and the single air control.

At certain stages of burning you will notice “jets” of swirling flame emerging near the air holes

to the rear of the firebox. This is not always visible depending upon the fuels and burn cycle

stage so there is nothing untoward happening if it cannot be seen.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charlton Jenrick Fireline Woodtec 5 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info