Bedienungsanleitung Charlton Jenrick Fireline Woodtec 5 (Seite 18 von 28) (Englisch)

707656

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

17 Woodtec Freestanding Issue 01.1 05/17

Should any difficulties arise over fuel quality or suitability, consult your local approved fuel

merchant.

7.7 Important Information for Wood Burning

With a full load of wood and burning near nominal output the stove will need to be refuelled

approximately every 45 mins -1.5 hours. One or two large logs will burn longer than a number of

smaller ones. Wood can usually be stacked higher in the stove than solid mineral fuel but care

must be taken that logs do not touch the baffle or the glass panel. Do not stack logs above the

level of the tertiary air inlet profiling in the rear ceramic firebox liners at the back of the stove.

Always make sure that flames are visible above the wood after re-fuelling for cleanest burning.

Burning without flames above the fuel will create unnecessary smoke. After re-fuelling open

the single air control fully to the Wood (left) side for 3 minutes or until the logs are fully

blackened to achieve full flames above the fuel.

Wood burns best on a bed of ash and it is therefore only necessary to remove surplus ash from

the stove occasionally.

Burn only dry, well-seasoned wood, which should have been cut, split and stacked - under cover

from rain - for at least 12-24 months with free air movement around the sides of the stack to

enable it to dry out. Burning wet or unseasoned wood will create tar deposits in the stove and

chimney and will not produce a satisfactory heat output. Wood that is not properly dry (‘dry’ is

considered to be less than 20% internal moisture content) uses up energy from the burn

process to evaporate the water inside the wood thus creating very poor conditions for

combustion. The main cause of burning problems with wood stoves is due to excessively damp

wood. Wood can appear perfectly dry on the outside but still contain 40-50% water on the

inside. A moisture meter can be purchased from stove and equipment suppliers if you wish to

check your wood source is correct. Split a log and check the inside as well as the outside.

7.7.1 Refuelling on to a low fire bed

If there is insufficient burning material in the firebed to light a new fuel charge, excessive smoke

emission can occur. Refuelling must be carried out onto a sufficient quantity of glowing embers

and ash so that the new fuel charge will ignite in a reasonable period. If there are too few

embers in the fire bed, add suitable kindling and firelighter if necessary to prevent excessive

smoke.

7.7.2 Fuel overloading

The maximum amount of fuel specified in this manual should not be exceeded, overloading can

cause excess smoke. Never load fuel above the centre of the tertiary air profiling in the back

ceramic firebox liner or allow them to touch the glass. All models max log diameter = approx.

150mm. Max length = 300mm for 5, 400mm for 5 Wide, 450mm 5 Xtra Wide models. A typical

fuel load is two logs, one log is acceptable ONLY if loading onto a hot, well established fire bed.

7.7.3 Operation with door left open

Operation with the door open can cause excess smoke and spillage into the room. The appliance

must not be operated with the appliance door left open.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charlton Jenrick Fireline Woodtec 5 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info