Bedienungsanleitung Charnwood Bay BX (Seite 8 von 20) (Englisch)

815476

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

CHIMNEY SWEEPING

TROUBLE SHOOTING

Where the chimney previously served an open fire, it is possible that

the higher flue gas temperature from a stove may loosen soot

deposits with the consequent risk of flue blockage. It is therefore

recommended that the chimney be swept a second time within a

month of regular use after installation.

The chimney should be swept at least twice a year. Where the top

outlet is used it will generally be possible to sweep the chimney

through the appliance.

First remove the fuel retainer, the throat plate and upper throat plate.

Then sweep the chimney ensuring that soot is removed from all

horizontal surfaces after sweeping.

In situations where it is not possible to sweep through the appliance

the installer will have provided alternative means, such as a soot door.

After sweeping the chimney the appliance flue outlet and the flue

pipe connecting the stove to the chimney must be cleaned with a flue

brush.

After clearing any soot from within the stove, replace the throat plate

(see Fig. 8) and the fuel retainer.

Fire Will Not Burn

Check that:

a) the air inlet is not obstructed in any way,

b) chimneys and flueways are clear,

c) a suitable fuel is being used,

d) there is an adequate air supply into the room,

e) an extractor fan is not fitted in the same room as the stove.

f) there is sufficient draw in the chimney. Once the chimney is warm a

draught reading of at least 1.25 mm (0.05 in.) water gauge (12Pa)

should be obtained.

Blackening of Door Glass

Differences in chimney draughts mean that the best settings of the air

controls will vary for different installations. A certain amount of

experimentation may be required, however the following points

should be noted and with a little care should enable the glass to be

kept clean in most situations:

Different types of sweep’s brushes are available to suit different

flueways. For prefabricated insulated chimneys the manufacturers

instructions with regard to sweeping should be consulted.

least once a month and more frequently if required. Let the fire out

and ensure it is cold before carrying out these operations. If

necessary, wear your Charnwood gloves to prevent irritation from

soot deposits.

The throat plate consists of two firebrick panels which rest on the

central bracket and the two side bricks. To lower, push the brick up

towards the topmost corner of the stove, and lower down diagonally

(see Fig. 8). Any sooty deposits should then be swept from the plate

and into the fire.

Return the throat plates to their correct position by reversing the

above method, ensuring they slot onto the bracket and rest securely

on the side panels.

OPERATING INSTRUCTIONS

Throat plate Side brick

Side View

Lowering the throat plate

Fig. 8 Throat plate position and lowering

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood Bay BX Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info