Bedienungsanleitung Charnwood Bay BX (Seite 10 von 20) (Englisch)

815476

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

UNPACKING THE STOVE

The stove arrives bolted and strapped to its pallet. There must be

adequate facilities for unloading and manoeuvring into position The

wrapping is first removed, then the stove released from the pallet by

removing 4 pallet bolts using a 10mm spanner. The pallet brackets

can now be removed from the stove by tilting it and using a 13mm

spanner to remove the bolts. The pallet is intended to be cut up and

used for kindling fuel.

Please take care when installing the stove that the requirements of

the Health and Safety at Work Act 1974 are met.

HEALTH AND SAFETY PRECAUTIONS

Some types of fire cement are caustic and should not be allowed to

come into contact with the skin. In case of contact wash with plenty

of water.

If there is a possibility of disturbing any asbestos in the course of

installation then please use appropriate protective equipment.

There must not be an extractor fan fitted in the same room as the

stove as this can cause the appliance to emit fumes into the room.

There must be an adequate air supply into the room in which the

appliance is installed to provide combustion air. The combustion air

supply must be via a permanently open vent. The requirement for

minimum free area is partly dependent on the design air permeability

of the house. In older properties the air permeability will be above

5.0m³/(h.m²), but in some modern properties it may be less. The

vent must be positioned such that it is not liable to blockage.

Minimium areas are given in the following table:

A fixed ducted air supply may be used as an alternative to the

traditional method of using a permanent open vent into a room to

supply air for combustion.

Ducted external air supply kits are available please contact

Charnwood for more information.

The ducted air kit is connected to the 100mm spigot on the

underside of the stove. If the stove is installed directly on a hearth,

without any additional stands, the ducted air supply will need to be

set into the floor with appropriate protection.

INSTALLATION INSTRUCTIONS

This stove is capable of intermittent operation, and is not suitable for

use in a shared flue system.

In addition to these instructions the requirements of BS.8303 and

BSEN 15287-1:2007 must be fulfilled. Local Authority Bylaws and

Building Regulations, including those referring to national and

European Standards, regarding the installation of Solid Fuel burning

appliances, flues and chimneys must also be observed.

CO ALARMS

Building regulations require that whenever a new or replacement

fixed solid fuel or wood/biomass appliance is installed in a dwelling a

carbon monoxide alarm must be fitted in the same room as the

appliance. Further guidance on the installation of the carbon

monoxide alarm is available in BS EN 50292:2002 and from the

alarm manufacturer's instructions. Provision of an alarm must not be

considered a substitute for either installing the appliance correctly or

ensuring regular servicing and maintenance of the appliance and

chimney system.

The outputs in the table are based on a 45 minute re-fuelling cycle

burning seasoned hardwood logs. All tests are carried out in

accordance with BSEN 13240.

In order for the appliance to perform satisfactorily the chimney height

must not be less than 4 metres measured vertically from the outlet of

the stove to the top of the chimney. The internal dimensions of the

chimney should preferably be 150-200 mm (6"- 8") either square or

SPECIFICATION

CHIMNEY

Air permeability

m³/(h.m²)

Minimum vent area cm²(in²)

Bay BX

>5.0

not required

<5.0

27.5 (4.3)

Bay BX

Output

5kW

(17,061BTU/h)

Mass

94.3kg

Flue Gas Temperature

279°C

Flue Gas Mass Flow

4.1g/s

Average Refuelling Cycle

0.75hrs

Maximum Log Size

Length 480mm

Diameter 75mm

Side

Back

Minimum distance from

combustibles mm

Uninsulated Flue

150

270

Minimum distance from

combustibles mm

Insulated Flue

100

130

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood Bay BX Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info