Bedienungsanleitung Charnwood Country 4 Blu (Seite 7 von 20) (Englisch)

815475

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

OPERATING INSTRUCTIONS

When Not in Use

If the fire is going to be out of use for a long period (for instance in

the summer) then to prevent condensation, and hence corrosion, the

air control should be left fully open and the fire door left ajar. It Is also

advisable to sweep the chimney and clean out the fire. Spraying the

inside of the door and firebox with a light oil, such as WD40, will also

help to keep all internal parts working well. After long periods where

the fire has been out of use, the chimney and appliance flueways

should be cleaned before lighting.

Door Seals

For the fire to operate correctly it is important that the door seals

are in good condition. Check that they do not become worn or

frayed and replace them when necessary.

Servicing

It is recommended that the fire is serviced once a year to keep it in

first class working order. After cleaning out the firebox thoroughly,

check that all internal parts are in good working order, replacing

any parts that are beginning to show signs of wear. Check that the

door seals are in good condition and that the doors seal correctly. A

servicing guide is available on request. Repairs or modifications may

only be carried out by the Manufacturer or their approved agents.

Use only genuine Charnwood replacement parts.

THROAT PLATE AND FLUEWAY CLEANING

It is important that the throat plate and all the stove flueways are kept

clean in order to prevent potentially dangerous fume emission. They

should be cleaned at least monthly, and more frequently if necessary.

It is necessary to let the fire out to carry out these operations.

To remove the lower throat plate, first remove the fuel retainer

(item ‘d’ page 5) to allow enough room so that the throat plate clears

the sides of the fire box when removed.

Slide the lower throat plate forwards so that it clears the back plate,

then slide it either right or left so that the opposite side clears the

retaining flange on the side plate and can be gently lowered. Any

sooty deposits should then be swept from the throat plate and into

the fire.

To return the lower throat plate to its correct position- At an angle,

insert the throat plate so that it sits on top of either the right or left

side of the retaining flange on the side plates. Raise the opposite side

of the throat plate and slide so that the throat plate is central and

supported by both side plates. Slide back so that the throat plate

rests neatly on the top of the back plate.

The upper baffle plate rests centrally on top of the air wash tubes.

The stud on the baffle plate should be located into the hole on the

bracket

Fig.2 Throat Plate Location

CHIMNEY SWEEPING

Where the chimney previously served an open fire, it is possible

that the higher flue gas temperature from a stove may loosen soot

deposits with the consequent risk of flue blockage. It is therefore

recommended that the chimney be swept a second time within a

month of regular use after installation.

The chimney should be swept at least twice a year. Where the top

outlet or vertical rear flue connector is used it will generally be

possible to sweep the chimney through the appliance.

First remove the fuel retainer and the upper and lower throat plates.

Then sweep the chimney ensuring that soot is removed from all

horizontal surfaces after sweeping.

In situations where it is not possible to sweep through the appliance

the installer will have provided alternative means, such as a soot

door. After sweeping the chimney the appliance flue outlet and the

flue pipe connecting the stove to the chimney must be cleaned with

a flue brush.

After clearing any soot from within the stove, replace the throat

plate (see Fig. 2 ) and the fuel retainer.

Different types of sweep’s brushes are available to suit different

flueways. For prefabricated insulated chimneys the manufacturers

instructions with regard to sweeping should be consulted.

Side view Inside view

The stud on the

upper baffle plate

is loacted into the

hole on the bracket

Upper throat plate

Brick throat plate

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood Country 4 Blu Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info