Bedienungsanleitung Charnwood Cove 1 (Seite 6 von 20) (Englisch)

632311

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

the grate bars. The ashpan is handled using the Door Opening tool

provided. Ensure that the tongue of the ashpan is protruding through

the slot in the top of the tool before lifting (See Fig.3). Care should

be taken to ensure that ash is cool before emptying it into plastic

liners or bins.

To make ash removal easier there is a special Charnwood ash carrier

available. This may be purchased from your supplier or, in case of

difficulty, from ourselves.

The grate should be kept in the closed position and should not be

riddled until the ash becomes so deep that it begins to block the

passage of air into the firebox at the sides or back of the grate. When

this is the case do not remove all of the ash using the riddling

mechanism but keep a layer about half an inch thick as this enables

the wood to burn more effectively. When lighting the fire a few small

dry logs with a good amount of kindling will help to get the fire up to

temperature quickly.

The stove is finished with a high temperature paint which will

withstand the temperatures encountered in normal use. This may be

cleaned with a damp lint-free cloth when the stove is cold. Should re-

painting become necessary then special high temperature paints are

available from your supplier or from Charnwood.

The glass in the door is a special ceramic glass which is able to

withstand high temperatures. Before cleaning the glass open the door

Special Points when Burning Wood

Cleaning

Cleaning the Glass

MAINTENANCE

and allow it to cool. Clean the glass using a damp cloth and then wipe

over with a dry cloth. Any stubborn deposits on the glass may be

removed with a proprietary stove glass cleaner or ceramic hob

cleaner. Some deposits on the glass may be burnt off simply by

running the fire at a fast rate for a few minutes. Do not use abrasive

cleaners or pads as these can scratch the surface which will weaken

the glass and cause premature failure. Aerosol spray cleaners should

not be used near the appliance whilst it is under fire.

If the fire is going to be out of use for a long period (for instance in

the summer) then to prevent condensation, and hence corrosion, the

air control should be left fully open and the fire door left ajar. It is

also advisable to sweep the chimney and clean out the fire. Spraying

the inside of the door and firebox with a light oil, such as WD40, will

also help to keep all internal parts working well.

After long periods where the fire has been out of use, the chimney

and appliance flueways should be cleaned before lighting.

For the fire to operate correctly it is important that the door seals

are in good condition. Check that they do not become worn or

frayed and replace them when necessary.

It is recommended that the fire is serviced once a year to keep it in

first class working order. After cleaning out the firebox thoroughly,

check that all internal parts are in good working order, replacing any

parts that are beginning to show signs of wear. Check that the door

seals are in good condition and that the door seals correctly. A

servicing guide is available on request. Repairs or modifications may

only be carried out by the Manufacturer or their approved agents.

Use only genuine Charnwood replacement parts.

It is important that the throat plate and all the stove flueways are kept

clean. They should be checked approximately once a week, by

looking up into the firebox for signs of soot or fly-ash on the throat

plate and at the sides of the firebox. If there are signs of a build up of

soot or fly-ash deposits then the fire must be let out in order to clean

the throat plate and flueways.

Before attempting to clean the throat plate and flueways ensure that

the fire is cold. Wear suitable gloves to prevent irritation from soot

deposits. To remove the throat plate lift the front edge up, pull the

When Not in Use

Door Seals

Servicing

THROAT PLATE AND

FLUEWAY CLEANING

Lift throat plate at front,

then pull forward and

swing down. For Cove 1

Remove tubes from front

supports before swinging

Throat plate down.

Fig. 4. Throat Plate

charnwood

OPERATING INSTRUCTIONS

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood Cove 1 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Charnwood Cove 1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info