Bedienungsanleitung Charnwood Cove 1 (Seite 7 von 20) (Englisch)

632311

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

plate forwards to align the slots with the support pegs and then hinge

the plate down from its back supports. Lift up from the back

supports and rotate to remove through the doorway (see Fig. 4).

The chimney should be swept at least once a year. Where a top

outlet is used it will generally be possible to sweep the chimney

through the appliance.

First remove the front firebar, side fire plates, and the throat plate.

Then sweep the chimney ensuring that soot is removed from all

horizontal surfaces after sweeping.

In situations where it is not possible to sweep through the appliance

the installer will have provided alternative means, such as a soot door.

After sweeping the chimney the appliance flue outlet and the flue

pipe connecting the stove to the chimney must be cleaned with a flue

brush.

After clearing any soot from within the stove, replace the throat plate

(see 4), the front firebar.

Check that:

a) the air inlet at the rear of the stove is not obstructed in any way,

b) chimneys and flueways are clear,

c) a suitable fuel is being used,

d) there is an adequate air supply into the room,

e) an extractor fan is not fitted in the same room as the stove.

f) there is sufficient draw in the chimney (once the chimney is warm a

draught reading of at least 0.10 inches water gauge (25Pa) should be

obtained).

Keeping the glass clean requires a certain amount of experimentation

due to the differences in the draw of different chimneys. The

following points should be noted and with a little care should enable

the glass to be kept clean in most situations:

a) The airwash relies on a supply of heated air to keep the glass clean,

CHIMNEY SWEEPING

Fig. side fireplates, and

Different types of sweep's brushes are available to suit different

flueways. For standard brick chimneys a wire centre sweep's brush

fitted with a guide wheel is recommended. For prefabricated insulated

chimneys the manufacturers instructions with regard to sweeping

should be consulted.

TROUBLE SHOOTING

Fire Will Not Burn

Blackening of Door Glass

therefore, when lighting the stove allow the fire bed to become well

established before closing the air control. This also applies when re-

fuelling the stove.

b) When re-fuelling keep the fuel as far back from the front firebar as

possible, do not try to fit too much fuel into the firebox.

c) Wet wood or logs overhanging the front firebars will cause the

glass to blacken.

d) There is a bypass slide that can be adjusted to suit the particular

installation. This allows a small amount of airwash air to enter the

stove even when the air control is closed. This can be adjusted to help

with keeping the glass clean when the fire is slumbering.

It is always more difficult to keep the glass clean when running the

stove very slowly for long periods.

Check that all flue connections and the blanking plate are well sealed.

It is also important that the chimney draw is sufficient (when the

chimney is warm a draught reading of at least 0.10 inches water

gauge should be obtained), and that it is not affected by down-

draught.

If fume emission does persist, then the

following immediate actions should be taken:

a) Open doors and windows to ventilate the room.

b) Let the fire out and safely dispose of the fuel from the appliance.

c) Check for flue or chimney blockage, and clean if required.

d) Do not attempt to re-light the fire until cause of fume has been

identified. If necessary, seek professional advice.

The most common cause of fume emission is flueway or chimney

blockage. For your own safety these must be kept clean.

Check that :

a) The door is tightly closed.

b) The air control is pushed in.

c) A suitable fuel is being used.

d) Door seals and air control flap pads are intact.

If the chimney is thoroughly and regularly swept, chimney fires should

not occur. However, if a chimney fire does occur push the air control

Fume Emission

Warning Note: Properly installed and operated this appliance will

not emit fumes. Occasional fume from de-ashing and re-fuelling

may occur. Persistent fume emission is potentially dangerous and

must not be tolerated.

Fire blazing out of control

Chimney Fires

charnwood

OPERATING INSTRUCTIONS

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood Cove 1 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Charnwood Cove 1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info